Models
>
MH1596CIR
MH1596CIR (CSSELEC) LG Range
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for MH1596CIR
Viewing 6 of 6
Keep searches simple, eg. "belt" or "pump".
$16.75
The turntable motor coupler connects the turntable motor to the tray. If the turntable on your microwave will not rotate, you may have a faulty motor coupler. The coupler commonly has a D shaped openi...
In Stock
Order now and your part arrives by Mar 20
In Stock
Order now and your part arrives by Mar 20
Special Order
In Stock
Order now and your part arrives by Mar 20
In Stock
Order now and your part arrives by Mar 20
Special Order
In Stock
Order now and your part arrives by Mar 20
In Stock
Order now and your part arrives by Mar 20
Special Order
Special Order
In Stock
Order now and your part arrives by Mar 20
In Stock
Order now and your part arrives by Mar 20
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for MH1596CIR
Viewing 5 of 5Won’t turn on
Fixed by these parts
How to fix it
Tray won’t turn
Fixed by these parts
How to fix it
No heat
Fixed by these parts
How to fix it
Door not closing properly
Fixed by these parts
How to fix it
Sparking
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Ellen from REDDING, CA
- Parts Used:
- MCK69074904
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
Sparks from an old wave guide that needed to be replaced
Put microwave on its side as my hands weren’t ready enough to hold it up while trying to push it in.
Put board on the door to hold it open.
Gently pushed the wave guide back as far as it would go. Then, I carefully pushed the front tabs in place. No bending. I had practiced on the old one first. Broke the 2 old tabs by pushing ... Read more back to hard so you need to be careful.
Put board on the door to hold it open.
Gently pushed the wave guide back as far as it would go. Then, I carefully pushed the front tabs in place. No bending. I had practiced on the old one first. Broke the 2 old tabs by pushing ... Read more back to hard so you need to be careful.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from PURCELLVILLE, VA
- Parts Used:
- 4370W1A006B
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
The new part was too thick for the worn out plastic ring which is obsolete.
Needed to raise the part to match the ring. I used peanut butter to hold plastic shim while replacing to hold it in place. Built in Oct. 2009.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Cesar from Miami, FL
- Parts Used:
- 4370W1A006B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Shaft socket was worn out
Pop old one out and replaced it with new one.
Was this instruction helpful to you?
Thank you for voting!