9114178589 Kenmore Range - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Jeffrey from Bolingbrook, IL
- Parts Used:
- WB36T10207
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers
an F7 code kept reaading on appliance
Codes are found in instruction manual taped to inside of oven by control panel. A code F7 is stickey touch panel.
Removed three screws holding panel, pushed back wire clip for cable plug in, remove wires, unscrewed control module from panel, put in new, reverse order to install.
Much cheaper than $800.00 the repairman wanted!
Removed three screws holding panel, pushed back wire clip for cable plug in, remove wires, unscrewed control module from panel, put in new, reverse order to install.
Much cheaper than $800.00 the repairman wanted!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Edward from Spring, TX
- Parts Used:
- WB36T10398
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
FO Code on display with beeps
Removed three screws from under control panel, which holds it in place. Carefully removed the panel from the oven. Very carefully removed the power strip block which connects the control panel to the control box. Remove the four screws
from the control box. Than replaces the old control box to the new control panel and attache the new power strip to control box. And put it all back together. May sounds confusing but, it's easy.
You'll see, you can do it!
from the control box. Than replaces the old control box to the new control panel and attache the new power strip to control box. And put it all back together. May sounds confusing but, it's easy.
You'll see, you can do it!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- BOYD from RIDGEWAY, SC
- Parts Used:
- WB36T10214
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
Control panel would short out-F7
Turn off electricity to oven. Remove 3 screws attaching panel to oven. Remove 2 screws on face plate. Unplug computer cord and replace w/ new panel.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Glenn from Charlotte, TN
- Parts Used:
- WB36T10209
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
F1 error-touch pad control panel bad
Turned off oven breaker at main panel. Took oven door off for easier access. Removed two machine screws from bottom of top panel. Removed (unplugged) control ribbon cable from electronic control module. Removed four screws that attach the electonic control module and then screwed it onto new replacement part. Replaced control panel on top of over and turned on electricity at main panel. Everything works. GOT PART THE DAY AFTER I ORDERED IT.... UNBELIEVABLE!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- jim from walton hills, OH
- Parts Used:
- WB36T10196
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
oven kepad not working
kept getting trouble code f7. replaced keypad control and all is well,very easy to replace.
Was this instruction helpful to you?
Thank you for voting!