79036719500 Kenmore Range

Replaced clock control by removing surface burner control knobs and plastic nuts, and then the cover over the oven control. Two screw hold the clock in place, after removal and disconnecting the plug-in you can reinstall the new clock control. The Heat Sensor inside the oven will also need to be replaced. It is located inside the oven ... Read more and attached with two screws; the back of the oven will need to be removed to unplug. Reverse removal procedure and turn the power back on to the stove.

Repair was quite easy, as long as you have the instructions for removing the door. The screws that hold the bottom of the door to the fixed hinge are placed into the side of the hinge assembly after removal; this holds the door at a 45 degree angle for easy removal. After that, just place the door on a flat surface and dismantle the door ... Read more from the inside. The inner glass is contained in a metal frame with another piece of glass; this frame comes apart easily using the clips in each side. The door assembles easily after the glass is replaced; just take your time and give yourself enough room to lay out the parts as you go. Good luck!

First, in order to easily access the oven door, I removed it by pulling straight out at the hinges. Then I removed the frame of the broken glass assembly by unscrewing the 2 screws at the bottom of the door and the 2 screws holding the door handle. I fit the new part in place, screwed the bottom 2 screws first, and then lined up the scr ... Read more ew holes in the assembly with the screw holes in the door handle and reattached the handle with the 2 other screws. IMPORTANT: ALWAYS USE A MANUAL SCREWDRIVER WHEN WORKING WITH THE GLASS ASSEMBLY...AND DO NOT TIGHTEN THE SCREWS FOR THE HANDLE TOO TIGHTLY (THE GLASS WILL SHATTER IF YOU DO!)