Models > 101933590

101933590 Kenmore Range

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for 101933590

Viewing 4 of 4
Backguard Section Diagram and Parts List for Kenmore Range
Backguard Section
Body Section Diagram and Parts List for Kenmore Range
Body Section
Cook Top Section Diagram and Parts List for Kenmore Range
Cook Top Section
Misc Parts Diagram and Parts List for Kenmore Range
Misc Parts
Keep searches simple, eg. "belt" or "pump".
Screw – Part Number: WP27001200
$7.30
Sold individually.
In Stock
Order now and your part arrives by Mar 19
Balancing Leg Spring – Part Number: 27239
No Longer Available
Bell Plug – Part Number: 40008401
This bell plug goes on the bottom of the agitator.
No Longer Available
DISCONTINUED – Part Number: 33521
No Longer Available
Air Filter (Poly) – Part Number: 36727
$6.32
In Stock
Order now and your part arrives by Mar 19
RING-RETAI – Part Number: 27197
No Longer Available
Lock Nut, 10-32 – Part Number: 29216
$6.25
In Stock
Order now and your part arrives by Mar 19
CLIP – Part Number: 36519
No Longer Available
Governor Shaft – Part Number: 37160
$6.25
In Stock
Order now and your part arrives by Mar 19
WIRE HARNESS – Part Number: 306812
No Longer Available
Switch – Part Number: 00031921
No Longer Available
BRKT MTG, COOLING FAN – Part Number: 36264
No Longer Available
View More

Questions and Answers

Be the first to ask our experts a question about this part!

Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
dennis from flushing, MI
Parts Used:
27239
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
shook violently in rinse mode... worse w light loads
Remove two sheet metal screws at bottom front. Tip up and remove front panel. Tip up top panel. Hold it up to allow access to rear of drum. Use soft piece of wire to loop around top of spring. Pull 4 springs up and off drum. Rotate the springs to release them from the base plate. Starting at the rear of the drum slip new spring end into washer base. Slip wire loop on the top of the new spring. Pull and stretch new spring onto drum. Repeat 3 more times. Replace front cover....you're done!
Read less
8 of 13 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
View More