Models
>
79040303412
79040303412 Kenmore Range
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
$26.35
This is a screw for your range or microwave. This part is sold individually. It has a pan head, a pointed tip for use with sheet metal, and an x-shaped drive. This screw is a #8, has 18 threads to the...
In Stock
Order now and your part arrives by Aug 13
In Stock
Order now and your part arrives by Aug 13
In Stock
Order now and your part arrives by Aug 13
$46.97
This genuine OEM oven temperature sensor probe monitors the internal temperature of the oven to ensure accurate and consistent cooking performance. By sending temperature readings to the control syste...
In Stock
Order now and your part arrives by Aug 13
In Stock
Order now and your part arrives by Aug 13
$53.85
This replacement light bulb provides clear illumination to improve visibility during appliance operation. It is commonly replaced when the original bulb burns out, flickers, or no longer produces adequate light.
In Stock
Order now and your part arrives by Aug 13
$62.45
This oven door hinge supports the door’s movement, allowing it to open and close smoothly while maintaining a tight seal during operation. Built from durable metal, it helps keep the door properly ali...
In Stock
Order now and your part arrives by Aug 13
In Stock
Order now and your part arrives by Aug 13
In Stock
Order now and your part arrives by Aug 13
In Stock
Order now and your part arrives by Aug 13
In Stock
Order now and your part arrives by Aug 13
Common Problems and Symptoms for 79040303412
Viewing 1 of 1
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Richard from MERCERVILLE, NJ
- Parts Used:
- 5303935059
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
Igniter failing to energize even though there was 120 volts being supplied.
Slide Range away from wall, unplug Range, remove rear cover (4) screws, removed burner assembly (5) screws, unplugged Igniter connector, loosen Igniter bracket, remove Igniter (2) screws. Reverse process to install new Igniter. I also wore latex gloves to prevent touching graphite portion of Igniter. Tested Broiler for operation, slid Ran
... Read more
ge back into position. All good.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Edward from NORWOOD, PA
- Parts Used:
- 5303935059
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Replace igniter
New part needed to be spliced to old connector with porcelain wire nuts then removed lower oven drawer to access the connection for igniter
Was this instruction helpful to you?
Thank you for voting!