Models
>
JGA9150ADP12
JGA9150ADP12 Jenn-Air Range
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for JGA9150ADP12
Viewing 1 of 1
Keep searches simple, eg. "belt" or "pump".
$47.20
This is a genuine OEM replacement part. This spark ignition electrode is what lights the gas that starts the burner on your range or cooktop. This electrode is part of the burner assembly, it sits nex...
In Stock
In Stock
$8.04
This is the replacement brass seal for your range or cooktop. It is made of brass and is approximately 1 inch in diameter. This part may also be known as the surface burner orifice holder seal. It pre...
In Stock
This part is the surface burner base for gas cooktops/ranges. This part comes with the spark electrode.
Special Order
Special Order
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for JGA9150ADP12
Viewing 3 of 3Will Not Start
Fixed by these parts
How to fix it
Gas igniter glows, but will not light
Fixed by these parts
How to fix it
Element will not heat
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- HUY from ALISO VIEJO, CA
- Parts Used:
- WPY0316773
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
Broken Electrode, no spark
Remove 2 screws holding the top burner. Remove 1 screw holding the electrode. Remove electrode from wiring using plier. Install new electrode and top burner
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Friendswood, TX
- Parts Used:
- WPY0316773
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Burner would not ignite when control in "light" position
Remove the two screws from the burner assembly (on top of the burner). Lift burner assembly from the cook top. Disconnect the electrode wire from the electrode. Remove the screw holding the electrode to the burner assembly (on bottom of burner). Install the new electrode and attach the electrode to the burner assembly. Attach the elec
... Read more
trode wire to the electrode. drop the burner assembly back into position on the cooktop. Attach the burner assembly using two screws.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Patricia from Overland park, KS
- Parts Used:
- WP74005890
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Spark igniter out
The primary spark igniters failed. Take the (small) screws out of the sides and bottom of the pan. The front of the pan must be removed from the bottom, because the front burner igniter wire is too short to allow reassembly once attached. Only other is the screws for the attachment bracket are larger than the holes. Suggest routing them o
... Read more
ut slightly to get them to grip the screws. Otherwise it is quite simple. Pull the connections with a needlenose and press the new wire connection back on firmly. Screw the screws back in the pan.
Read less
Was this instruction helpful to you?
Thank you for voting!