10RJ45-A Hotpoint Range - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- William from SAN DIEGO, CA
- Parts Used:
- WB2X5103
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Pliers, Screw drivers
Old gasket (seal) broken and leaking
The oven is 70 years old and used several times a week so getting it to come apart wasn't working.
Used a light oil and some thinner to work loose the old seal, which was stuck pretty good, removed it by lightly prying the seal lip wider and pulling it out, mostly piece by piece. The worked in the new one and became of the light oil, it went in rather easy. Had to trim an inch or so from each end and wiped down and cleaned up. No more problems....
Used a light oil and some thinner to work loose the old seal, which was stuck pretty good, removed it by lightly prying the seal lip wider and pulling it out, mostly piece by piece. The worked in the new one and became of the light oil, it went in rather easy. Had to trim an inch or so from each end and wiped down and cleaned up. No more problems....
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jon from Bishop, CA
- Parts Used:
- WB2X5103
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
worn out gasket
Used a putty knife and dental pick to remove old gasket remnants and installed new gasket with putty knife and thumb pressure
Was this instruction helpful to you?
Thank you for voting!