Models
>
H1100PRW
H1100PRW Hardwick Range
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for H1100PRW
Viewing 4 of 4Keep searches simple, eg. "belt" or "pump".
$7.95
This is a multi-use screw mostly used in dryers. It has a diameter of #10, length of one inch, and thread size of 16. Remember to follow safety practices and instructions provided in the manufacturer ...
In Stock
In Stock
$105.22
This square burner grate has sides measuring almost nine inches long. It is all black in color. Sold individually.
In Stock
In Stock
$7.76
This is a multi-use frame screw that fits a variety of power tools and equipment. Follow installation instructions and safety practices provided in the manual by the manufacturer.
In Stock
In Stock
Special Order
This door handle spacer assembly contains two screws and two spacers.
No Longer Available
In Stock
This valve automatically cuts off the flow of gas at a certain pressure.
No Longer Available
Once this valve senses the desired heat, this part will open up and allow the gas to travel to the oven burner.
No Longer Available
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
-
Customer:Paul from Arlington, MA
-
Parts Used:74010590
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers, Wrench set
pilot lit but oven would light
replaced the oven safety valve. This device uses heat from the pilot to hold open a valve that allows gas from the thermostat control to feed the main burner. It works by boiling the liquid mercury in the sensor bulb, producing the pressure to hold open the valve. My sensor had failed from old age, leaking the mercury.
Spilled mercury needed to be collected and properly disposed, and the valve was a tough fit among the sheet metal parts that form the path for the gas to the burner slots. The valve is secured by flat head sheet metal screws and the gas plumbing is a tapered pipe fitting. The sensor bulb has a small steel spring to hold it in the proper spot to sense the pilot light.
I used gas-rated pipe dope on the gas fitting, probably unnecessarily. Valve faces only 1/2 psi pressure...
Spilled mercury needed to be collected and properly disposed, and the valve was a tough fit among the sheet metal parts that form the path for the gas to the burner slots. The valve is secured by flat head sheet metal screws and the gas plumbing is a tapered pipe fitting. The sensor bulb has a small steel spring to hold it in the proper spot to sense the pilot light.
I used gas-rated pipe dope on the gas fitting, probably unnecessarily. Valve faces only 1/2 psi pressure...
Was this instruction helpful to you?
Thank you for voting!
-
Customer:Linda from Jenison, MI
-
Parts Used:WP2003X030-00
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:
original light grey color grates stained and unsightly--no amount of scrubbing or cleansers would make them look nice.
Opened the box and took out the black color grates~~removed discolored grates and put the new ones on. Looks like a brand new stove and much nicer to look at as it is the first thing you see when you enter the kitchen.
Was this instruction helpful to you?
Thank you for voting!
-
Customer:Raymond from BLOOMINGTON, MN
-
Parts Used:4396923
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
-
Tools:
Purchased home but stove had no broiler pan.
Purchased 2 piece broiler pan from this site
Was this instruction helpful to you?
Thank you for voting!