Models
>
ZDP30L4H3SS
ZDP30L4H3SS General Electric Range
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for ZDP30L4H3SS
Viewing 9 of 9Keep searches simple, eg. "belt" or "pump".
In Stock
In Stock
$123.65
Also known as spark electrode. This part helps your burner ignite and produce flame.
In Stock
In Stock
In Stock
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- NORMAN from THOMSON, GA
- Parts Used:
- WB24X10091
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
old switch would not turn off
remove c clip, remove two wires
install new switch,
replace c clip, replace two wires
test
have a cup of coffee
install new switch,
replace c clip, replace two wires
test
have a cup of coffee
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tom E. from SANTA CRUZ, CA
- Parts Used:
- WB44X10018
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Outer heating element shorted out, likely due to age and damage from lower rack changing heights over 10 year period of use.
Turned off breaker at electrical panel. Confirmed power to stove was off with multimeter, as I couldn't pull stove out to unplug it without significant hardwood floor protection in place and extra equipment to "slide" the stove out. Removed all racks. Cleaned the inside of the stove. Unscrewed the two screws holding the element to the bac
... Read more
k wall and pulled the element out from the back wall, revealing the wiring connections. Held the wire on one side with needle nose pliers and slid the element from the wire retaining clip. Attached the new element on that side to the wire retaining clip. Held the wire on the other side with needle nose pliers and removed the other wire retaining clip. Pulled out the old element and placed it on the floor. Installed the other end of the new element into the wire retaining clip. Confirmed they were both securely attached, crimped down a bit on each retaining clip for good measure and pushed the element and wire ends back into the stove body. Installed the two screws and re-installed the racks. Turned on the breaker at the electrical panel. Confirmed that the lights, igniters and over all worked. Done. 15 minutes. Took just as long getting out the tools, turning things off and on and returning tools to the garage than it did to replace the element. Fun part was finding the model number, finding the web site to purchase the element, and waiting a week to get it. But really easy and the stove works again.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Marilyn R from Adel, IA
- Parts Used:
- WB26T10007
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
Convection Fan Motor Quit
Used the nut driver to take out the bad motor and installed the new one.
Was this instruction helpful to you?
Thank you for voting!