Models
>
JGSP20GER1BG
JGSP20GER1BG General Electric Range
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for JGSP20GER1BG
Viewing 5 of 5
Keep searches simple, eg. "belt" or "pump".
$170.80
A self-cleaning cycle that will not begin may point to a failed door lock assembly. This automatic unit uses a small motor to move the oven latch and a switch to confirm whether the door is locked. Th...
In Stock
Order now and your part arrives by Oct 3
Special Order
Special Order
Special Order
Special Order
Special Order
Special Order
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Nopadon from Arden, NC
- Parts Used:
- WB27K5187
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Screw drivers
Heat come up about 150 degrees and stop.
I removed the whole unit out by pulled the plug at the bottom and pulled the unit out, unplug the power cord , turn the gas line off, separate gas line from the stove. I pulled the unit out to have more room for me to work on it. I took the top part out and right hand side panel out. Now you can see the old clock/oven control (ERC II
... Read more
C). I wrote down the color of wire to the lettering on the controller board. I pulled the wires out from the old one. Then I put wires back to the new clock/oven control. I reinstalled and put the gas line back and plug in power cord. I test the unit. It is work very fine.
Read less
Was this instruction helpful to you?
Thank you for voting!