Models
>
GCT30106WG
GCT30106WG General Electric Range
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
In Stock
Order now and your part arrives by Mar 26
In Stock
Order now and your part arrives by Mar 26
This gasket goes under the burner bowl to help protect the glass from high heat. Sold individually.
No Longer Available
This part is sold individually. It is white on the top side, and black underneath. Used for gas ranges. You may need to order the drip bowl seal.
No Longer Available
This part is sold individually. It is white on the top side, and black underneath.
No Longer Available
This trim ring is white on the top side and black underneath.
No Longer Available
This igniter is used to light the top surface burner on a range/stove. Sold individually.
No Longer Available
In Stock
Order now and your part arrives by Mar 26
In Stock
Order now and your part arrives by Mar 26
In Stock
Order now and your part arrives by Mar 26
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for GCT30106WG
Viewing 1 of 1
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Steve from Broken Arrow, OK
- Parts Used:
- WB32M10
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Drip pans needed to be replaced.
Simiple repair. Determined drip pan size (sm, med., lg.) removed 2 screws holding drip pan, placed gasket around new drip pan and installed. Repaired took less than 5 minutes.
Was this instruction helpful to you?
Thank you for voting!
Large and small Burner Drip Bowls needed to be replaced
The drip bowls of my stove had to be replaced. The tough job about this is that the bowls need to be ordered which we did. The order was sent to my house within a couple days. The drip bowls were replaced and they look and work just fine. The gas stove is about 10 yrs old and it needs the parts special ordered now. I used to wash and use
... Read more
a bit of elbow grease but this time it required too much effort. So an easy replacement did the trick.
Read less
Was this instruction helpful to you?
Thank you for voting!
Porcelain chipped around screws
Removed old rusted screws, removed old drip bowls, removed seals from old drip bowls carefully cleaned seals and replaced them on the new drip bowls. I re-installed the new drip bowls with new stainless steel screws. ( be careful not to tighten the screws to tight )
Was this instruction helpful to you?
Thank you for voting!