JP340BMB General Electric Range - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Larry from Mattawa, WA
- Parts Used:
- WB23M9
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Intermitently the switch would stick on high.
Pulled unit from the counter top, removed all side screws holding the top on and set the top off. Removed switch mount section, Identified the terminal wire locations. I then removed the old switch and connected the wires per my diagram. Returned all screws, tested the burner for opeation and reset the cooktop back into the counter hole and secured.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Carole from Grand Haven, MI
- Parts Used:
- WB03T10025
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
broken knob on gas range
pulled off old knobs and replaced with new knobs.
Only one was broken, but wanted all of them to match so ordered enough for entire range. Worked perfectly. Looks great!
Only one was broken, but wanted all of them to match so ordered enough for entire range. Worked perfectly. Looks great!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dennis from Fillmore, CA
- Parts Used:
- WB03T10025
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Range Knobs were Broken
I pulled off the broken knobs and put on the new knobs. Effortless.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- LAURANCE from RIO VERDE, AZ
- Parts Used:
- WB03T10025
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Stripped knob-could not turn on burner
Just put it on the control post
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- William from Perryton, TX
- Parts Used:
- WB30T10043
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Stove Top Element Heat Varies
Removed stove top from counter, removed glass top by removing 10 phillps screws, removed control bracked, unplugged connectors(wires) on old control and plugged into the correct position on the new control, replace control on the bracket then reinstalled the stove top and placed the stove top back into counter.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from PEABODY, MA
- Parts Used:
- WB03T10025
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Knob Brock
Only filled this out so people know how easy it was to do business with this company and how fast I received my order even with snail mail. I would definitely order from them again
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rita from Eads, TN
- Parts Used:
- WB03T10025
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
2 Knobs were broken
Just pushed the new knobs down where they went
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gary from Manchester, MD
- Parts Used:
- WB30T10043
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Small Element on cook top fails to function
Turned of the electric at the circuit breaker. Removed the cable clamps for the electric feed cable to enable free movement of cooktop. Lifted cooktop from the counter and propped up on counter ledge. Removed control knobs. Removed perimeter screws, 8 phillips, from around the edge of the cook top surface where it attaches to the sheet metal housing and lifted glass top off. Removed the failed burner and disconnected the four electrical leads. Removed the mounting tabs from the old burner and installed them on the new burner. Attached the electrical leads to the new burner and tightened with pliers. Reattached glass top and knobs, reinstalled in counter, clamped the electrical cable, flipped the breaker and tested. All good.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Diane from SaddleBrooke, AZ
- Parts Used:
- WB03T10025
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
finish on stovetop knobs were abraded.
Replaced them with 2 new knobs. They arrived almost immediately; terrific service.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- anthony g from MOUNT PLEASANT, SC
- Parts Used:
- WB30T10043
- Difficulty Level:
- Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers, Socket set
needed burner replacement
There are 18 sheetmetal screws not 8
The GE SREWS HAVE AN INTEGRATED WASHER which causes the philips head to STRIP these needed to be drilled out!!!
The glass top was GLUED to the sheetmetal box and did not come off without a fight
The GE SREWS HAVE AN INTEGRATED WASHER which causes the philips head to STRIP these needed to be drilled out!!!
The glass top was GLUED to the sheetmetal box and did not come off without a fight
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- NEIL from FRIENDSWOOD, TX
- Parts Used:
- WB23M9
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Element would not turn off
Set cooktop circuit breaker to off.
Remove hold-down straps from underneath cooktop.
Lift cooktop from counter.
Remove screws holding glass top to base.
Remove screws holding switches
Remove two screws holding element switch.
Move wires from bad switch to new switch.
Reinstall.
Remove hold-down straps from underneath cooktop.
Lift cooktop from counter.
Remove screws holding glass top to base.
Remove screws holding switches
Remove two screws holding element switch.
Move wires from bad switch to new switch.
Reinstall.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Hazel C. from Jonesborough, TN
- Parts Used:
- WB03T10025
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Burner knob had broken
Just replaced the knob, no tools needed. The knob I ordered was the exact type of my old one so was no problem. Thanks for fast shipping and correct item.
Was this instruction helpful to you?
Thank you for voting!