ERDE48NGH Dacor Range - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- David from CAMILLUS, NY
- Parts Used:
- DE81-08448A
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
F2 Alarm and oven beeping
Replaced relay board
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from BUENA VISTA, CO
- Parts Used:
- DE81-04994A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Replaced bottom relay control panel
First disconnected power to the oven at circuit breaker box. Then, Removed top front control panel, held by four screws exposed when top oven door is opened. Was able to move control up and out of the way without disconnecting. The relay control panel is visible on the right. I was able to reach all connectors with needle nose pliers and then remove the panel with needle nose to release clips and use screw driver to gentle pry up. Installed new unit by attaching back connectors and then setting panel down onto clips. Finished with attaching front connectors. Reattach front control panel.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Marilyn from INDIAN WELLS, CA
- Parts Used:
- DE81-05142A
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Screw drivers
Dacor sent a different bulb # which I CANNOT get back into the oven.
I have contacted Dacor repeatedly with no response, by both phone and left my return contact and email.
I could not be more disappointed in Dacor. All this for a problem which is listed as a home maintenance issue. A light bulb for $41.77 that I cannot install.
I could not be more disappointed in Dacor. All this for a problem which is listed as a home maintenance issue. A light bulb for $41.77 that I cannot install.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Keith from MIAMI, FL
- Parts Used:
- DE81-06694A
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Flame was not even all around.
Cleaned the brass ring and replaced the cap.
New brass rings may be an improvement too.
New brass rings may be an improvement too.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- ALLEN from Newton, KS
- Parts Used:
- W10820043
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers, Socket set, Wrench (Adjustable), Wrench set
The Shaft On The Direct Drive Was Worn
Removed the control panel and the cabanit. Then removed the adjutatior . Removed the motor and gear box slid the old shaft out and put the new one in put back together. Took about one hour .
Was this instruction helpful to you?
Thank you for voting!