Models
>
EORS227
EORS227 (BLK) Dacor Range
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
$38.79
This 12-volt, 20-watt halogen bulb uses a G4 bi-pin base to restore interior or task lighting in compatible cooking appliances. Its clear light makes the cooking area easier to see during use. Replace...
Special Order
$42.85
This temperature sensor checks the heat inside the oven and sends the reading to the control board, the board uses this reading to keep the set temperature, replace the sensor if the oven heats too sl...
In Stock
Order now and your part arrives by Sep 25
In Stock
Order now and your part arrives by Sep 25
An oven that suddenly stops heating may have an open high-limit switch. This safety device monitors heat near key electrical parts and interrupts power if the temperature reaches its set limit. Its 22...
Special Order
In Stock
Order now and your part arrives by Sep 25
In Stock
Order now and your part arrives by Sep 25
Special Order
Special Order
In Stock
Order now and your part arrives by Sep 25
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- JEFFREY from KNOXVILLE, TN
- Parts Used:
- DE81-02250A, DE81-09571A, DE81-05658A
- Difficulty Level:
- Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
My hinge receptacle was groove was worn away cause hinge to get jam
Pulled oven about 6 inch out from cabinet. Then remove side cover piece. Push out hinge receptacle with screwdriver. Replace with new hinge receptacle and reverse process
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from MCKINNEY, TX
- Parts Used:
- DE81-02331A
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Two striped out screw heads
Purchased a screw extractor set from the local Ace Hardware (SpeedOut). Be sure and carefully follow the screw extractor instructions as written (counterclockwise turn). Removed old screws and replaced them with new screws supplied by PartSelect.
Was this instruction helpful to you?
Thank you for voting!