ERSD36S Dacor Range - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Sarah from FORT COLLINS, CO
- Parts Used:
- DE81-03937A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
Temp sensor is failing
I did not do the repair since the part shipped was not the correct one. I have contacted Customer Service by phone and mail and nothing has been resolved.
I would, at least, like to return the incorrect part. An new one would be great but not holding out hope.
I would, at least, like to return the incorrect part. An new one would be great but not holding out hope.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Marilyn from INDIAN WELLS, CA
- Parts Used:
- DE81-05142A
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Screw drivers
Dacor sent a different bulb # which I CANNOT get back into the oven.
I have contacted Dacor repeatedly with no response, by both phone and left my return contact and email.
I could not be more disappointed in Dacor. All this for a problem which is listed as a home maintenance issue. A light bulb for $41.77 that I cannot install.
I could not be more disappointed in Dacor. All this for a problem which is listed as a home maintenance issue. A light bulb for $41.77 that I cannot install.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Keith from MIAMI, FL
- Parts Used:
- DE81-06694A
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Flame was not even all around.
Cleaned the brass ring and replaced the cap.
New brass rings may be an improvement too.
New brass rings may be an improvement too.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from MCKINNEY, TX
- Parts Used:
- DE81-02331A
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Two striped out screw heads
Purchased a screw extractor set from the local Ace Hardware (SpeedOut). Be sure and carefully follow the screw extractor instructions as written (counterclockwise turn). Removed old screws and replaced them with new screws supplied by PartSelect.
Was this instruction helpful to you?
Thank you for voting!