Models > ERSD48 > Instructions

ERSD48 Dacor Range - Instructions

Jump to:

All Instructions for the ERSD48
1 - 6 of 6
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Keith from MIAMI, FL
Parts Used:
DE81-06694A
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Flame was not even all around.
Cleaned the brass ring and replaced the cap.
New brass rings may be an improvement too.
5 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
David from CAMILLUS, NY
Parts Used:
DE81-08448A
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
F2 Alarm and oven beeping
Replaced relay board
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Sarah from FORT COLLINS, CO
Parts Used:
DE81-03937A
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Temp sensor is failing
I did not do the repair since the part shipped was not the correct one. I have contacted Customer Service by phone and mail and nothing has been resolved.

I would, at least, like to return the incorrect part. An new one would be great but not holding out hope.
3 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Marilyn from INDIAN WELLS, CA
Parts Used:
DE81-05142A
Difficulty Level:
Very Difficult
Total Repair Time:
More than 2 hours
Tools:
Screw drivers
Dacor sent a different bulb # which I CANNOT get back into the oven.
I have contacted Dacor repeatedly with no response, by both phone and left my return contact and email.
I could not be more disappointed in Dacor. All this for a problem which is listed as a home maintenance issue. A light bulb for $41.77 that I cannot install.
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Janice from Hoover, AL
Parts Used:
DE81-04591A, DE81-02696A
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
All cooktop eyes started sparking at the same time, had to turn off at circuit breaker
Called local repair company and said that it wasn't fixable, had to go. It was 12 years old and they don't make them to last anymore. Next door neighbor is handy. He came over and got the part out and said to go downtown and get replacement part. It was late and I looked on the internet and saw your Hours of Op, called and got a Saint named Lee. He and I went back and forth with photos and emails. He needs to be promoted. I have never had such a fun time at that hour discussing cooktop parts nor gotten the respect and customer service that is usually reserved for experienced repairmen, much less a woman. He went above and beyond. Plus he had personality, patience and encouragement. Instead of the $1200 that we had prepared for to replace our cooktop, we were out $35. Lee was phenomenal. I asked to speak to his supervisor to commend him and he declined! That is one self-fulfilled agent you have there. And I am so glad you sent this survey so that I get to tell you how amazing Lee is!!!
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the ERSD48
1 - 6 of 6