UXL6036YSS0 Whirlpool Range Hood - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Jeffrey from MILTON, FL
- Parts Used:
- W11387938
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Screw drivers
one switch went out on the range hood controlling the lights.
The repair did not happen. Parts select sent me the wrong part. They sent a cover plate without any switches.
I;m still waiting for the correct part.!!!!!!!!!!!!!!!!!!!!!!
I;m still waiting for the correct part.!!!!!!!!!!!!!!!!!!!!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Anneliese from Sarasota, FL
- Parts Used:
- W10169961A
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Old grease filters were coming apart due to two tiny lost screws which had popped out. Tried to replace them at ACE Hardware and found nothing that tiny! Therefore just ordered replacement grease fikterd.
The only poroblem I had was finding the Model number. I entered WWW….instead of WVW (my eyesight and error??.Receiving the new filters was prompt! THANK YOU!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- NICHOLAS & LEIGH from CHARLOTTE, NC
- Parts Used:
- W11387938
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers
SWITCH CONTROL UNIT HAD BROKEN OFF FROM ONE END OF ITS INTERIOR MOUNTING
Removed and cleaned to overhead grease trap filters which required a sink full of detergent some wire wool pads and and much elbow grease. This is probably a service task that should be performed at least annually for hoods in frequent use. And be careful not to cut your fingers on some of the sharp interior edges.
With the grease filters removed it was then possible to access the switch unit from the inside of the hood. Used a small Phillips screwdriver to loosen and remove the two fastening screws and removed and replaces the whole unit.
Refitting was the reverse of the above process.
With the grease filters removed it was then possible to access the switch unit from the inside of the hood. Used a small Phillips screwdriver to loosen and remove the two fastening screws and removed and replaces the whole unit.
Refitting was the reverse of the above process.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Brian from LEANDER, TX
- Parts Used:
- W11387938
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- More than 2 hours
Control panel broken
Amazing. PartSelect shipped me the wrong part and then wouldn't refund shipping cost to return it. They need to change their shipping policy as it now states they refund shipping if they were the cause of the mistake.
Was this instruction helpful to you?
Thank you for voting!