Models > KIRD802VSS1

KIRD802VSS1 KitchenAid Range Hood

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for KIRD802VSS1

Viewing 1 of 1
VENTILATION PARTS Diagram and Parts List for KitchenAid Range Hood
VENTILATION PARTS
Keep searches simple, eg. "belt" or "pump".
Fan Switch – Part Number: WPW10240604
$132.88
This part activates the fan motor.
Special Order
Motor Control – Part Number: W10235661
$151.65
This genuine OEM control motor helps operate the downdraft ventilation system by turning the fan on and off as needed. It plays a key role in proper ventilation by supporting smooth fan operation and ...
On Order
Push Button Assembly – Part Number: W10235663
$65.23
Special Order
Fuse – Part Number: WPW10235651
$58.09
Special Order
SWITCH – Part Number: W10235643
No Longer Available
Motor – Part Number: WPW10235654
No Longer Available
FILTR-GRSE – Part Number: W10235659
No Longer Available
CNTRL-ELEC – Part Number: W10235652
No Longer Available
HARNS-WIRE – Part Number: W10235649
No Longer Available
SCREW-ELVT – Part Number: W10235656
No Longer Available
COVR-CNTRL – Part Number: WPW10235664A
No Longer Available
FILTR-GRSE – Part Number: WPW10287462
$160.95
Special Order
View More

Questions and Answers

Be the first to ask our experts a question about this part!

Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Howard from Bonita, CA
Parts Used:
W10235663, W10235661
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
On / Off switch broken
The retractable range ventilator stopped working in the up positiion. Removed grease filter. Removed existing CONTRL-MTR. Disconnected 2 flat control cables and connected them to new CONTRL-MTR and installed the new CONTRL-MTR. Also replaced the push button switch. Replaced grease filter. In testing the unit the ventilater would retra ct but not come back up unless I lifted the top trim piece with the push button switch in it and stuck a tooth pick in the hole to activate the switch. The down rod of the new pushbutton switch was too short. I then noticed the old push button switch had a very thin hard plastic tube extending the down rod. I transfered the tube to the new switch and it worked OK.
Read less
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
View More