Models
>
ZVB36SB4SS
ZVB36SB4SS General Electric Range Hood
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for ZVB36SB4SS
Viewing 1 of 1
Keep searches simple, eg. "belt" or "pump".
Sold individually. This filter is for a 36" range hood that requires 2 filters.
No Longer Available
Special Order
Special Order
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for ZVB36SB4SS
Viewing 1 of 1
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Anthony from Stevensville, MD
- Parts Used:
- WB27X24888
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Wrench set
Controller board fried
Disconnected power and removed electrical cover
Disconnected wires from old controller one a time and connected to new controller as to not mismatch wire connections. Left new controller hanging off wires.
Raised vent and held using wood blocks to expose gap to use 1/4 inch wrench to undo screws from the inside (poor design for ... Read more replacing the controller - this was the bulk of my time.) if this didn't work, I would have had to disassemble more of the downdraft.
Installed new controller.
Removed chocks, enabled power and tested...after verified, re-installed electrical cover.
Disconnected wires from old controller one a time and connected to new controller as to not mismatch wire connections. Left new controller hanging off wires.
Raised vent and held using wood blocks to expose gap to use 1/4 inch wrench to undo screws from the inside (poor design for ... Read more replacing the controller - this was the bulk of my time.) if this didn't work, I would have had to disassemble more of the downdraft.
Installed new controller.
Removed chocks, enabled power and tested...after verified, re-installed electrical cover.
Read less
Was this instruction helpful to you?
Thank you for voting!