Models
>
JVB37ABB
JVB37ABB General Electric Range Hood
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for JVB37ABB
Viewing 2 of 2Manuals & Guides for JVB37ABB
Click to downloadInstall
Installation Instructions
(0.69MB)
Manual
Owner's Manuals
(1.12MB)
Specs
Product Specifications Sheet
(0.18MB)
Keep searches simple, eg. "belt" or "pump".
This part is the replacement membrane switch for your range hood. It is approximately 4 inches in length, and the part of the switch that you push is black in color. The membrane switch or downdraft v...
No Longer Available
When ordering this part you must order also order the switch membrane and the trim.
No Longer Available
Special Order
Special Order
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for JVB37ABB
Viewing 2 of 2Will Not Start
Fixed by these parts
How to fix it
Drawer is hard to open and or close
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Richard from Chardon, OH
- Parts Used:
- WB24X10115
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Downdraft wouldn't work at all..... broken sensor
I pulled up the wires that the membrane switch hooks to and connected the new one with the new sensor pushed them down the opening. Took the sticky paper off the up and down button and stuck it too the indentation where it goes and there you have it as good as new! Works great!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Anthony from Stevensville, MD
- Parts Used:
- WB27X24888
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Wrench set
Controller board fried
Disconnected power and removed electrical cover
Disconnected wires from old controller one a time and connected to new controller as to not mismatch wire connections. Left new controller hanging off wires.
Raised vent and held using wood blocks to expose gap to use 1/4 inch wrench to undo screws from the inside (poor design for ... Read more replacing the controller - this was the bulk of my time.) if this didn't work, I would have had to disassemble more of the downdraft.
Installed new controller.
Removed chocks, enabled power and tested...after verified, re-installed electrical cover.
Disconnected wires from old controller one a time and connected to new controller as to not mismatch wire connections. Left new controller hanging off wires.
Raised vent and held using wood blocks to expose gap to use 1/4 inch wrench to undo screws from the inside (poor design for ... Read more replacing the controller - this was the bulk of my time.) if this didn't work, I would have had to disassemble more of the downdraft.
Installed new controller.
Removed chocks, enabled power and tested...after verified, re-installed electrical cover.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- jeffrey from hickory, NC
- Parts Used:
- WB24X10115
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
putting membrane switch in
Received membrane switch quick after I ordered it. Connected switch to downdrafts system in less than 15 minutes. Tested system to make sure it worked. very happy with partsselect shipped quickly after ordering.
Was this instruction helpful to you?
Thank you for voting!