FHWC3050RSA Frigidaire Range Hood

REMOVAL
1 ) POWER SWITCH ASSY DOWN AT BREAKER BOX
2 ) LOWER FILTER COVER BY PRESSING FRONT CORNERS, LET HANG
3 ) REMOVE FILTERS
4 ) UNSCREW 2 #2 PHILLIPS HEAD SCREWS LOCATED AT THE REAR OF THE PANEL HOLDING PANEL TO HOOD BODY
5 ) SLIDE PANEL TO THE REAR TO DISENGAGE
6 ) REMOVE SELECTOR KNOBS FROM KNOB AS ... Read more SY (EXTEND KNOBS AND WIGGLE FREE)
7 ) REMOVE 2 #1 PHILLIPS HEAD SCREWS HOLDING KNOB ASSY TO SWITCH ASSY, LOCATED INSIDE KNOB ASSY
8 ) UNSCREW THREADED SLEEVE ON KNOB ASSY
9 ) REMOVE KNOB ASSY
INSTALLATION
1 ) DISASSEMBLE NEW PART INTO COMPONENT PIECES
2 ) SLIDE RETAINER PORTION OF KNOB ASSEMBLY THROUGH APPROPRIATE HOLE IN PANEL
3 ) SCREW THREADED SLEEVE ONTO RETAINER
4 ) ATTACH KNOB ASSY TO SWITCH ASSY USING 2 # 1 PHILLIPS SCREWS
5 ) INSERT SELECTOR KNOBS INTO KNOB ASSY, MAKE SURE THAT THE MARKED (LIGHT OR FAN) KNOB CORRESPONDS TO THE CORRECT SWITCH
6 ) INSERT TABS ON FRONT OF PANEL INTO HOOD BODY
7 ) INSERT 2 #2 PHILLIPS SCREWS INTO REAR OF PANEL TO ATTACH TO HOOD BODY
8 ) REINSERT FILTERS
9 ) RAISE AND SECURE FILTER COVER
10) POWER BREAKER BACK ON

RECOMMEND TEST AFTER INITIAL ASSEMBLY BETWEEN STEPS 5 AND 6. GOOD LUCK