Models
>
020410-0
020410-0 Pressure Washer
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Models for 020410-0
Click on the best match to narrow your results.
Keep searches simple, eg. "belt" or "pump".
$30.64
This is a genuine OEM sourced component which is specially designed for Craftsman pressure washers. It is an identical replacement for a missing or damaged outlet that was originally installed on a ne...
In Stock
In Stock
In Stock
$214.28
Pressure washer pump kit. If the pressure washer is leaking water, the pump may need to be rebuilt or replaced. If the pump is more than a few years old, and you use the pressure washer fairly often, replace the pump.
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
Common Problems and Symptoms for 020410-0
Viewing 1 of 1
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Carl from ARCADIA, FL
- Parts Used:
- 192914GS
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
The copper fitting on the chemical injection broke.
I order the part from this site and received it within a week. the only problem was that spring was missing out of the sealed bag. NO PROBLEM!!! I cut a ball point pen spring to fit and everything works just fine. You just have to remember to put the spring in first, then the ball bearing and then the rubber o-ring.If you put them in back
... Read more
wards you pressure will fed directly into your chemical container!!
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Anthony from RIDGEFIELD, CT
- Parts Used:
- 189971GS
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Supplied hose has "press on" fitting on one end, washer does not accommodate it
One can either pull off the plastic fitting on one end (the one with an o-ring) and press the plastic tubing onto the pressure washer detergent inlet (located just behind the high pressure hose outlet/connector). The other end of the device is then inserted into a jug of pressure washer detergent and the lowest pressure nozzle or nozzle
... Read more
setting selected to allow detergent to be drawn up into the washwater stream with the pressure washer running. One can observe the detergent flowing into the washer if all is good! If one cannot pull off the plastic fitting on one end (the other fitting, to be left!, has a "screen" on its end - the fitting can be cut off the plastic tubing with a utility knife.
Read less
Was this instruction helpful to you?
Thank you for voting!