01433-0 Briggs and Stratton Pressure Washer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Seikai from MARICOPA, CA
- Parts Used:
- 497680
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
starter rewind cord broke
I found the model number of the Briggs & Stratton engine on the inside of the engine housing. Ordered a new starter-rewind unit, as the old cord broke and the thing was well worn. The instructions were clear enough, but to get the old starter off I had to drill out four rivets, which just spin around when you try. I used a hacksaw, chisel, pliers, whatever worked on each rivet; this took a while. When they were finally removed, the new starter pull unit was relatively easy to install with the small nuts and bolts provided. On the Yard Machines log splitter, putting back the engine housing is quite tricky; you have to jostle the thing into place, get the pull handle above the cover and line up the bolt holes.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Leonard from SAGINAW, MI
- Parts Used:
- 187879GS
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- More than 2 hours
Had stripped thread had to rethread and install pump unloaded rebuild kit.
The reinstall was the hardest because the amount of tension with the spring. Had to cobble something together to hold spring tension until I got the new nut plug started. To bad you don’t give instructions and or tools to help with the actual install.
Was this instruction helpful to you?
Thank you for voting!