JPM-13CS (708524) Jet Planer Jointer

This is an authentic OEM replacement part for certain models of Jet, Powermatic, and Wilton tools that is sourced from the manufacturer. To ensure that this will fit your tool, please see the "Model C...

This ball bearing is 17 mm and fits a variety of gardening power tools. The ball bearing has two contact rubber seals on each side and two non-contact metal shields on each end as well. Tip: if your t...

This eight (8) pin sprocket is compatible with some models of Jet planers/molders. It is a genuine OEM replacement part. This part drives the chain. Sprockets are frequently replaced because of their ...

This flat washer is designed to fit a variety of power tools. The washer helps distribute the pressure evenly between parts and has multiple applications depending on your specific tool. Check the dia...

This washer fits table saws, as well as other gardening tools. This washer provides a tight seal between parts. For the accurate location and application in your specific tool, refer to the diagram pr...

It is a genuine replacement part that is supplied directly from the original equipment manufacturer for use with a variety of equipment. Washers are generally utilized to provide a tight seal between ...

This part is an OEM from Powermatic. The socket set screw is compatible with a wide variety of power tools. The metal screw is sold individually, and a hex key is needed for making the replacement. It...

This flat washer fits the following tools: saws, drills, planer jointers, and angle grinders. The washer helps prevent nuts and bolts from tearing or pulling through material because it creates a bear...

This is a set screw for various power tools. This part is like a machine screw, but with no head. It screws all the way into threaded holes, and rests with, or just below the surface. Most commonly us...

This is a hex nut for power tools. It is size M10, with a 1.5 thread pitch. This is the most common hexagonal fastener. It has internal threads that screw on to the shank of a hex cap screw, or a bolt.

This is sold as a set of three knives. The knives attach to the cutterhead and are made out of metal. These are OEM parts sourced directly from the manufacturer and used in planers and molders made by...