CN890II Max Nailer - Parts

This authentic OEM part has been sourced directly from Max. These washers are used to help secure and seal connections in your nail gun. Rubber washers help limit the vibration in between parts of you...

This authentic OEM part has been sourced directly from Max. This replacement o-ring is used on the trigger valve assembly. Be sure to properly lubricate o-rings before you place parts back inside the ...

This is an identical replacement for a damaged or a missing spring that was installed on a new unit. It is commonly utilized to apply tension on the connected components. Keep in mind this high-qualit...

This is a genuine OEM sourced part which is specially designed for use with Max nailers. It is an identical replacement for a missing or faulty spring that was installed on a new unit. The part helps ...

This genuine OEM part has been sourced directly from Max. Overtime the cylinder cap seal will wear down and becoming less effective, is if that happens you might notice air leaking from where the fram...

This genuine OEM part has been sourced directly from Max. This 1Ap9 replacement o-ring is part of the trigger valve assembly. O-rings help create proper seals within the nail gun, this helps ensure th...

This is an authentic Max replacement part. When the trigger is pulled a nail leaves the magazine and the driver punches it into the surface the head of the nail gun is pressed against. The trigger is ...

This authentic OEM part has been sourced directly from Max. The contact lever sits underneath the trigger. As you pull the trigger the contact lever presses against the trigger valve assembly. All of ...

This item is available as an individual replacement part. The o-ring attaches to the main piston unit and is made of rubber. A set of pliers and an allen wrench may be needed during the replacement of...

This is an authentic Max replacement part that has been sourced from the original manufacturer to be used with pneumatic nailers. The plastic cap is part of the magazine assembly and is used to cover ...

This genuine manufacturer-sourced part is specially designed for Max pneumatic nailers. It is an important component which provides an air-tight seal for the head valve. Over time it will wear out and...