6127905123 Kenmore Miscellaneous - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Kate from Jacksonville, FL
- Parts Used:
- EDR3RXD1
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- 30 - 60 mins
there were directions
We didn't know where the product went and it was very difficult to install.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Leroy from Perkiomenville, PA
- Parts Used:
- EDR3RXD1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
six months the light turns red. time to replace filter
First I shut the water off to the refrigerator.then i pushed the big button in the middle of the grille below the refrigerator door. pulled out the old filter, took the front cap off the old filter put it on the new filter. took the two red caps off the new filter. pushed the filter in till it locked in place. all done! Turned the back on.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Victoria from Beaverton, OR
- Parts Used:
- EDR3RXD1
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Water filter replacement
It's simple enough in theory: read the side of the box and follow the instructions. BUT you need to really push the knob in pretty hard (I am a girl, and my hand strength isn't that good). If you don't, when you turn the knob, the filter won't come out, then it's tougher. So: make sure the knob pops before you turn!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kenneth from SAn Francisco, CA
- Parts Used:
- EDR3RXD1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
change the water filter light was on.
It was ridiculously easy. Push the button on the filter canister holder at the base of the refrigerator and the spring-loaded mechanism came out smoothly. I unplugged the old filter, took the cap off the new on and plugged it in. After reinserting the filter canister holder and locking it in place, I heard the whoosh of water once again moving through the filter. Very satisfying and very easy to do.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Karen from san diego, CA
- Parts Used:
- EDR8D1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Needed to replace my refrigerator water filter with a new one.
I took out the old one-no tools needed-and put in the new one. Just half a twist and pukk down, then twist in new one following arrows!
I have never had to turn off the water to do this. I just put a towel under the old one when I take it out. No mess and really simple!
I have never had to turn off the water to do this. I just put a towel under the old one when I take it out. No mess and really simple!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Baerbel from Jacksonville, FL
- Parts Used:
- EDR3RXD1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Change Out Filter
It turn one turn on the filter holder, pull out and put new filter in done
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Leslie from Nipomo, CA
- Parts Used:
- EDR3RXD1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water Filter needed to be replaced
It was SOOO easy, I turned and popped out the old filter and turned and snapped in the new one....I don't even think it took a whole minute to replace!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Roy from The Villages, FL
- Parts Used:
- EDR3RXD1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Refrigerator indicated that water filter needed replacement
It took less than 5 minutes to remove the old filter and install the new one. Push a button and the old one pops out, stick in the new one, and you're done.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Matt from Oxford, GA
- Parts Used:
- 12002353
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Pliers, Screw drivers
Motor Froze
Make sure to release the springs and pulleys before you try to tackle the bolts that hold the motor base to the bottom of the washer. Mine were a bit rusty and took some force to break loose. Also it's a good idea to take pictures of how everything sits before you disassemble as the pictures in the repair kit are not very clear. Other than that it was pretty straight forward. Wiring was a breeze. . . . Good luck
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joseph A from Sachse, TX
- Parts Used:
- EDR8D1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Filter too old.
This filter is located inside the refrigerator in the upper left corner. I turned off the water supply at the wall, unscrewed the old filter, placed the new one in, and turned the water back on. It took less than five minutes.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Debbie from Tyler, TX
- Parts Used:
- EDR3RXD1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
water filter needed replacing
followed the instructions on the box
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- walter from watertown, WI
- Parts Used:
- 12002353
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Socket set
the motor burnt out
took washer into the garage, removed front cover & disconnected the wiring. Then i removed the motor assembly. Piece of cake to finish job.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Denise from Hoschton, GA
- Parts Used:
- EDR3RXD1
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
It was just time to replace the water filter.
We took out the old filter and put in the new one. Ran out a few gallons of water then it was ready to use.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sandra S from Topeka, KS
- Parts Used:
- EDR3RXD1
- Difficulty Level:
- Difficult
- Total Repair Time:
- 15 - 30 mins
The wrong filter was sent the first time.
I removed the cap from the filter pushed a lever and removed fliter. I replaced the old filter, removed the caps on the new one and slid it into channel after replacing the outer cap. I removed water from the spigot for 4 mins. and it was ready to go. I pushed the reset button to get the green light to come on.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- JAMES from MESA, AZ
- Parts Used:
- 9014
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
change filter every year
took out the old one and put in the nw one
Was this instruction helpful to you?
Thank you for voting!