793829900 Kenmore Miscellaneous - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Eric from Seabeck, WA
- Parts Used:
- 12002351
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers, Socket set
Washer motor start windings burned up
The motor was easy to replace: unplug the wiring harness, slip off the belts, release the tension springs from the motor carriage with needle-nose pliers, and then unbolt the motor carriage with socket set and remove from the washer. Remove the pulley from the old motor with allen wrench and transfer the carriage to the new motor. Reverse operation for everything and you are back in business. The hardest part was the far back screw holding the carriage, a wobble extension helped.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- jeff from shepherd, MI
- Parts Used:
- 12002351
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
motor went out
simply removed old motor and replaced with new
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bob from Windsor, CA
- Parts Used:
- 12002351
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Wrench set
Washer would fill with water but not agitate, spin or drain.
Unplug the machine and disconnect the two water hoses. Use a short phillip screwdriver to remove two screws from the bottom front of the machine. Lift of the front panel to expose the motor. Lay the machine on its back on a 4 x 4 so the drain hose won't be damaged. If the screws appear rusted spary Kroil on them and let it soak for 45 - 60 mins. Remove the two belts. Remove the pulley via the set screw. Remove the four nuts to free the motor and slide plate. Undo all the wires. Remove the four nuts holding the slide plate. Install the new motor.
Was this instruction helpful to you?
Thank you for voting!