This charcoal filter is a genuine OEM replacement part for your microwave. The filter is used to trap and eliminate food odors that result from cooking. If your exhaust fan is not working properly, or...
This part is a replacement glass cooking tray for your microwave. The cooking tray rotates when the microwave is running, and helps your food cook evenly. As it is made of glass, these glass cooking t...
The microwave door interlock switch prevents the microwave from starting if the door is open. If your microwave will not start when the door is closed, or it continues running if the door is opened, t...
Also known as the coupler. This driver is located directly under the glass turntable, and over the motor. This part helps the glass turntable to rotate.
This is an authentic OEM replacement part. This screw is commonly used in the assembly of refrigerators, microwaves, ice makers, ranges, and smokers. Due to varied uses we recommend you refer to model...
Ask our experts a question about this part and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched. Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Walt
January 8, 2022
How to place electric control panel
For model number GH7208XRS3
Hi Walt,
Thank you for your question. Before you begin this repair, unplug the microwave from the electrical outlet and use a Phillips head screwdriver to unthread the mounting screws securing the grill. With the screws removed, open the microwave door and slide the grill to the left to remove it. Then remove the control panel mounting screw. Next, lift the control panel up to detach it. Note the orientation of the wires connected to the back of the control board and depress the locking tabs if necessary to disconnect the wires. Then use a screwdriver to remove the screw securing the grounding wire and set the panel on a sturdy surface. Next, release the ribbon connector attached to the electronic control board and unthread the screws securing the electronic control board to the housing and remove the board. Prepare the new control board for installation by removing the protective coverings. Then make sure the switch cable is inserted through the hole in the control panel housing and then place the electronic control board into the housing. Follow the steps in reverse. Plug the microwave back in and your microwave should now work for you. We hope this helps! Good luck with the repair!
There was no "fixing" per say but we still could not use the microwave without the plate. This has to be one of the biggest plates for a microwave. We ordered this through your company and we had it three days later. THREE DAYS! We had expected anywhere from 1-2 weeks. My husband was so impressed he bookmarked your site for future re
... Read moreference. Thank you for being so efficient and prompt. The glass turntable fit like a glove! Sincerely, Mark and Lia Hammond
I removed the screws along the top, side and bottom of the door, stuck a butter knife between the outer door and inner door assemblies, then simply removed the two screws holding the handle.
Remove the filters and use a Torx driver to remove two screws holding the motor. The wires on on the motor are held in place by a plastic clamp that must be pried open on one side. That's all it takes to replace the drive motor. Everything else that makes the turntable spin lifts off from inside the microwave.