UMV1152CAQ16 Maytag Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Lori from Salt Lake City, UT
- Parts Used:
- 6802A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Grease filters were missing from the over-the-stove microwave
Why a tenant would remove and discard the grease filters without replacing them is beyond me! But, I removed the filters from the package and slid them into place. Two minutes tops. I would like to add that I ordered these on Thursday afternoon, and I had them on Saturday; awesome customer service!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Patricia from Santa Cruz, CA
- Parts Used:
- DE67-00180A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The microwave turntable stopped rotating.
I ordered a new coupler and dropped it into the center hole, jiggled it until it fell into place, put the turntable back on the track, and voila, fixed! It was ridiculously easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- TIFFINI from BUFFALO, WY
- Parts Used:
- WP3405-001034
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Microwave would continue to run even when door was open. (even if no time was left on timer)
Unplugged Microwave, Removed vent cover (2 screws on top of microwave, then slide cover to the left, then forward) Removed control panel (1 screw at top of panel) then removed the two screws that hold in the door switch assembly. (these you will only see by opening the microwave). Located lower door switch, removed connecting wires, and pulled switch by releasing small plastic tab which held it in. Put new switch in place, reconnected wires, then reconnected door switch assembly. Reconnected control panel, and then put the vent cover back on. Tested microwave and it no longer runs when the door is open. Super easy fix, and was done in under 5 minutes.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Nick from Fenton, MO
- Parts Used:
- DE67-40063A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Suspect light bulb was touching glass, and cracked glass due to too much heat.
I unscrewed one screw and droped the glass light bulb cover, bent the light bulb up so it wouldn't break the glass again, removed the broken glass and installed new glass by bending the tabs over the glass to hold it in place and re-inserted the cover, then screwed the retaining screw back in. Done in 3 min.. PartsSelect.com seems to be one of the few online parts ordering place that has schematics and easy to navigate site. Perfecto!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Elaine from Allison Park, PA
- Parts Used:
- WPDE97-00672A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Bought microwave and it had no hanging screws with it.
Ordered part and screwed in. Part could not be found in hardware store even though it was just a long set of screws. Agent quickly identified part with model number of microwave and it was at my home the next morning for installation. Great service!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mike from Paso Robles, CA
- Parts Used:
- WPW10126786
- Difficulty Level:
- Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers, Wrench set
microwave acts like its working but won't heat.
Replaced the magnetron and diode. Microwave works prefect now.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Vicki from Phoenix, AZ
- Parts Used:
- 6802A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Microwave Vent Hood Filters
Not so sure this would qualify as "instructions", but I only needed a screwdriver because the "D" rings of the old vent filters broke off and I had to pry to old ones out. Keep in mind, I am mechanically disadvantaged and can barely change an A/C filter ... that being said, all I did for this order was input my Model number and PartSelect found the correct replacement part. I receive the parts super quick (faster than the other 2 purchases I did that day). The only bummer was the packaging ... super huge box for small tiny parts. Otherwise, I now know where to go for replacement parts. This project should be a "no-brainer" for most DYI's, so getting the right parts with just a model number was lifesaving for me :0)
Was this instruction helpful to you?
Thank you for voting!