4018922990 Kenmore Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- John from Timonium, MD
- Parts Used:
- 502967
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
dryer not heating
removerd screws open control panel remover old timer install new timer replace cover on control panel repace screws done
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Corinth, MS
- Parts Used:
- 502967
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Socket set
Breaker for dryer kept tripping out
The 5-cycle timer eventually failed on our Amana dryer and these were the symptoms leading up to the failure. First symptom was the timer would emit a squeak or squeal when the timer knob was pushed in. Then more recently the panel breaker kept tripping out. I shut the breaker off, pulled the plug, and dismantled the dryer panel to look at the timer. No noticeable fault or failure. Took a chance, ordered the replacement timer from PartSelect, and before installing wrote all the model and other numbers off both the old and new timers. They matched (Model 275 BEF) & (Kingston Model 275). Pulled the wire tabs one at a time off the old timer, and pushed onto same tab on new timer. Re-assembled the panel, plugged in the dryer, and turned the breaker on. Put the dryer through a few test drying cycles and it ran like new. The timer was a perfect fit and replacement, and all problems were eliminated. Runs like new!
Was this instruction helpful to you?
Thank you for voting!