Models > JMC1150WS00 > Instructions

JMC1150WS00 Jenn-Air Microwave - Instructions

Jump to:

All Instructions for the JMC1150WS00
1 - 10 of 10
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
tad from tamarack, MN
Parts Used:
WPM0805101
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
microwave oven blew fuse
First I removed upper front grill by removing two Philips head screws on top and pulling off. This exposed the Philips head screw which holds control panel in place. After removing screw I pushed up on panel and it came off to expose fuse. With needle nose pliers I removed old fuse and again with pliers held new fuse in position. With the help of a bladed screwdriver, I pushed new fuse into holder, then replaced panel, screw and grill. This took less than 15 minutes even as one of the wires on control panel pulled out of connection and took some time to locate where to reconnect, otherwise was an easy fix
.
24 of 37 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Denice from Montgomery, AL
Parts Used:
WPM0805101
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
microve stopped working
Jenn-Air Microwave would not turn on. Clock worked , light worked, timer worked and would count down .I changed' Part #0813140 Switch, Micr} cost $8.99 plus shippingNow it works Thank You for good advise
12 of 22 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
connie from madison, NC
Parts Used:
WPM0805101
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Died while heating lasagna
Removed 4 small star head screws from back of microwave, lifted body off, removed blown fuse and replaced with new one (found where cord enters). This model is stainless inside and out and I like it a lot. It is also sold by Daewoo and a few other manufacturers.
9 of 15 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Deborah from STRUM, WI
Parts Used:
WPM0805101
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Microwave went pop and nothing would work.
I mistakenly thought I had to remove the microwave to get to the back, not so. I would have had access to what I needed to unscrew; but I have to admit the hassle of taking it down and putting it back equals having to work on it attached to the shelf-your call on how you do this. I unscrewed the front top to remove the vent piece that is across the top front of the microwave. This will reveal the control panel screw. (While you have the vent removed you might want to clean the vent and the exposed filter.) carefully lift and pull out control panel. I unplugged a piece as the wires were tied tight. It will not completely detach, so carefully tip it back from exposed insides. The fuse is not clear but white with silver ends so look in upper right for it. I popped it out and replaced it. Replugged the wired part to cover and carefully fit tabs in and slide down to secre. Replace screw, replace vent piece and secure screws on top of microwave. I plugged it in to test before putting it back above my stove.
6 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
TIFFINI from BUFFALO, WY
Parts Used:
WP3405-001034
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Microwave would continue to run even when door was open. (even if no time was left on timer)
Unplugged Microwave, Removed vent cover (2 screws on top of microwave, then slide cover to the left, then forward) Removed control panel (1 screw at top of panel) then removed the two screws that hold in the door switch assembly. (these you will only see by opening the microwave). Located lower door switch, removed connecting wires, and pulled switch by releasing small plastic tab which held it in. Put new switch in place, reconnected wires, then reconnected door switch assembly. Reconnected control panel, and then put the vent cover back on. Tested microwave and it no longer runs when the door is open. Super easy fix, and was done in under 5 minutes.
9 of 20 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Richard from CALIFORNIA, KY
Parts Used:
WPM0805101
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
No power to any microwave functions
Access is via RT. SIDE Panel as you face microwave. There are three screws on the bottom right edge to loosen. After that the side panel slips down and off. the fuse is located in the rear near where the power cord comes in. It is the white ceramic tube 1/4" in dia. and 1-1/2" long. Pull it out like any fuse and replace with new one. Reassemble and you are done!
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Charles from Lake Havasu City, AZ
Parts Used:
DE31-10104A
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Rotate motor for Micrwave turntable failed
Turn off power to microwave (kitchen circuit breaker) Remove 3 sheet metal screws bottom front, disconnect electrical connections to motor and lights, remove defective motor(1 screw), replace with new unit, replace screw, re-attach bottom (3) screws, test. Replacement motor cost via this supplier was 1/3 of what local appliance repair store would have charged.
1 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Clifton C from Kingsland, TX
Parts Used:
4713-001012
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Bulb out
Pretty easy tear down and assembly once I removed it from cabinet (built in micro)
Was this instruction helpful to you?
Thank you for voting!
Customer:
JOE from CENTERREACH, NY
Parts Used:
DE47-20009A, WPM0805101
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
no power to unit after replacing fuse
went to you tube and found a segment compatible to my issue.called the web site and ordered the thermostat fuse and ceramic fuse in case i had the wrong one purchased at the locale H/Depot. The only issue was I did not know that there was 2 different thermo fuses,,one controls fan and the other a basic one. luckily the fan wasn't the one that was blown.The woman i spoke to was very helpful and my order was AT MY HOUSE in less then 24 hours.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Valerie from Rock Springs, WY
Parts Used:
DE74-00023A
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Cooking tray shattered
My daughter was trying to run the microwave timer and ended up nuking the cooking tray, which shattered. First web place I found wanted 55$ for this tray and this site sold it for 19.99. It shipped super quickly. I am very pleased with this company!
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the JMC1150WS00
1 - 10 of 10