JVM1630SPC01 General Electric Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Margaret from TOANO, VA
- Parts Used:
- WB25X10030
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
bulb burned out under the microwave that lights the cooktop underneath
got a screwdriver and opened the glass door over the light bulb - changed the bulb and put the glass door back with the screwdriver.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Charles from CLAYTON, NJ
- Parts Used:
- WB06X10610
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Tripping circuit breaker, broken micro switch locking pin
1. Unplug unit
2. Open door, remove two screws above the top trim piece, slide and remove trim.
3. Remove screw behind control board and top left corner, then release from position.
3b. Unplug all wire terminations and set control panel aside.
4. Remove two screws securing latch board, lift and rotate board out of position, remove three micro switches, xfer monitor switch actuator from lower pin in old board and insert in new. Install new door switches and reverse procedure to complete repair.
Note 1. Take care to located new latch board so holding tabs line up, pass through frame, and openings for door tangs line up with openings in frame before securing with screws.
Note 2. A long magnetic screwdriver is helpful.
2. Open door, remove two screws above the top trim piece, slide and remove trim.
3. Remove screw behind control board and top left corner, then release from position.
3b. Unplug all wire terminations and set control panel aside.
4. Remove two screws securing latch board, lift and rotate board out of position, remove three micro switches, xfer monitor switch actuator from lower pin in old board and insert in new. Install new door switches and reverse procedure to complete repair.
Note 1. Take care to located new latch board so holding tabs line up, pass through frame, and openings for door tangs line up with openings in frame before securing with screws.
Note 2. A long magnetic screwdriver is helpful.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from FORREST CITY, AR
- Parts Used:
- WB25X10030
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Light bulb went out on my microwave/ventahood. It's the bulb under the microwave that lights up the cooktop area.
Using a screwdriver, removed the cover, pulled out the bad bulb, and easily put in the new one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- mark from SUMMERFIELD, FL
- Parts Used:
- WB06X10625
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
noisy microwave turntable
I never knew why it made noise till I looked at the break down on this web site and found it was missing rotating ring since it was new. But unfortunately, I never received turntable ring which was ordered on 12/19/2022 now its tracking says Wednesday, 12/21/2022
9:36 AM
In transit
CAMP HILL, AL it has been stuck there all this time still not on its way to Florida. I don't understand did fedx put on southwest airlines?
9:36 AM
In transit
CAMP HILL, AL it has been stuck there all this time still not on its way to Florida. I don't understand did fedx put on southwest airlines?
Was this instruction helpful to you?
Thank you for voting!