Models
>
JES1289SK02
JES1289SK02 General Electric Microwave
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for JES1289SK02
Viewing 2 of 2
Manuals & Guides for JES1289SK02
Click to downloadKeep searches simple, eg. "belt" or "pump".
In Stock
Order now and your part arrives by Mar 28
Special Order
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for JES1289SK02
Viewing 2 of 2
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- William from KETTLE FALLS, WA
- Parts Used:
- WB24X10103
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Pliers, Screw drivers
Trip breaker when opening door
Door microswith was stuck on. This is caused, I discovered, by frequently stopping the oven, while running, by opening the door rather than using the stop button. Causes the switch to arc and eventually fail. This causes the safety microswitch to trip the breaker when door is opened. There are little nubs sticking up on the spade connecto
... Read more
rs. You must squeeze them down before you can remove them from the switch. The main door switch is the upper one, mounted at an angle. You have to remove the latch assembly to remove the switch. The problem was obvious once I got the switch out. This problem could also blow the fuse, but in my case the breaker tripped first. Use an ohmmeter to check switch and fuse. The door switch is normally open. The safety switch is normally CLOSED. Instructions inside were helpful and described this problem. So, avoid this repair by always stopping oven with stop button!
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- reval from ely, NV
- Parts Used:
- WB27X10743
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
blown fuse
Removed the three screws holding the cover on. then rmoved the two wires from the capacitor. Removed the screw holding the end of the zener diode to the chassis. Removed the diode from the capacitor. installed the new capacitor and replaced the blown fuse then reversed the removal process.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rebecca from EDINA, MN
- Parts Used:
- WB06X10500
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
The original feet, two disappeared. Uneven microwave.
Fast & easy. I was able to determine that this foot would work from the descriptions on online!! Thanks
Was this instruction helpful to you?
Thank you for voting!