Models
>
FPMO209RFDY
FPMO209RFDY Frigidaire Microwave
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for FPMO209RFDY
Viewing 3 of 3
Keep searches simple, eg. "belt" or "pump".
$45.04
The relay switch may also be known as the door micro switch and is a part for your microwave. The function of this part is to monitor the door latch and communicate whether the door latch is open or c...
In Stock
In Stock
In Stock
In Stock
Special Order
In Stock
In Stock
In Stock
Special Order
In Stock
On Order
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for FPMO209RFDY
Viewing 6 of 6Won’t turn on
Fixed by these parts
How to fix it
No heat
Fixed by these parts
How to fix it
Door stuck closed
Fixed by these parts
How to fix it
Tray won’t turn
Fixed by these parts
How to fix it
Door not closing properly
Fixed by these parts
How to fix it
Noisy
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Tim from Chicago, IL
- Parts Used:
- 5304493153
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Timer would run but the microwave won't start
I first removed the top plate above the microwave door (3 screws), then I removed the plate containing the buttons and clock. The microwave has 3 relay switches and they are in a little holder. The holder was too difficult to remove so I just removed the bottom switch and replaced. The microwave started right up.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- steve from New Bern, NC
- Parts Used:
- 5304440021
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Turntable stoped working
Removed the 3 screws to drop the lower panel and, removeed the turn table plate and ring. Then removed the 2 screws holding the motor, the 2 wires attached to the motor and removed the old motor.Replaced the new motor in the reverse order. DO NOT FORGET TO UNPLUG THE MICROWAVE FIRST.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Steve from Moorhead, MN
- Parts Used:
- 5304493153
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
microwave wouldn't turn on but timer worked.
was told buy a repair person to check the door micro switches as it was a common problem. removed the top plastic air grill to get access to the screw that holds in place the control cover. After unplugging the unit, i took out the (2) screws that held in the switches and removed them (3). One switch was a bit melted so i tested it with a
... Read more
12 volt battery and it was bad. Ordered a new one from Part select and got it fast . Works great .
Read less
Was this instruction helpful to you?
Thank you for voting!