Models > MW7695GS

MW7695GS Amana Microwave

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for MW7695GS

Viewing 3 of 3
Keep searches simple, eg. "belt" or "pump".
If you discover that the glass cooking tray in your microwave is damaged, you may have to replace it to operate the microwave properly. The glass cooking tray connects to the turntable of the microwav...
In Stock
Order now and your part arrives by Aug 18
This is a ceramic fuse for a microwave. It is just over 1 inch long. This fuse is 20 amps and 250 volts. This part powers your microwave. If your appliance is not heating properly, or is not turning o...
In Stock
Order now and your part arrives by Aug 18
In Stock
Order now and your part arrives by Aug 18
The turntable tray support holds the turntable tray while allowing the tray to rotate.
In Stock
Order now and your part arrives by Aug 18
$30.75
This part is also known as a rectifier.
On Order
This is an electronic device that holds a charge of electricity.
In Stock
Order now and your part arrives by Aug 18
No Longer Available
$192.57
Special Order
Special Order
In Stock
Order now and your part arrives by Aug 18
No Longer Available
No Longer Available

Common Problems and Symptoms for MW7695GS

Viewing 4 of 4
Won’t turn on
Fixed by these parts
Fixing Fixing
How to fix it
No heat
Fixed by these parts
Fixing Fixing
How to fix it
Doesn’t shut off
Fixed by these parts
Fixing
How to fix it
Tray won’t turn
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
tad from tamarack, MN
Parts Used:
WPM0805101
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
microwave oven blew fuse
First I removed upper front grill by removing two Philips head screws on top and pulling off. This exposed the Philips head screw which holds control panel in place. After removing screw I pushed up on panel and it came off to expose fuse. With needle nose pliers I removed old fuse and again with pliers held new fuse in position. With th e help of a bladed screwdriver, I pushed new fuse into holder, then replaced panel, screw and grill. This took less than 15 minutes even as one of the wires on control panel pulled out of connection and took some time to locate where to reconnect, otherwise was an easy fix
.
27 of 43 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Denice from Montgomery, AL
Parts Used:
WPM0805101
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
microve stopped working
Jenn-Air Microwave would not turn on. Clock worked , light worked, timer worked and would count down .I changed' Part #0813140 Switch, Micr} cost $8.99 plus shippingNow it works Thank You for good advise
15 of 30 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
connie from madison, NC
Parts Used:
WPM0805101
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Died while heating lasagna
Removed 4 small star head screws from back of microwave, lifted body off, removed blown fuse and replaced with new one (found where cord enters). This model is stainless inside and out and I like it a lot. It is also sold by Daewoo and a few other manufacturers.
9 of 17 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!