Models
>
P1191401M
P1191401M Amana Microwave
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
In Stock
Order now and your part arrives by Jul 25
In Stock
Order now and your part arrives by Jul 25
Special Order
Special Order
This microwave turntable cooking tray is thirteen inches in diameter. It is made of glass and is entirely clear.
No Longer Available
This white tripod roller support for microwave tray is seven inches long.
No Longer Available
Special Order
This gasket is gray and is made of a spongy material. This gasket is used for many air conditioners. It will come to you at the length you specify: one foot, two feet, whatever you require. When order...
No Longer Available
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Annika from Rancho Cucamonga, CA
- Parts Used:
- R0154048
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Turntable not moving, intermittent "grinding sound"
The microwave is installed above my gas range, and has a sheet that holds the vent screens and light bulb cover. I removed 3 screws holding this sheet in place at the front edge closest to me. The edge furthest from me (closest to the wall) had grooves that the sheet slid into. I could not set the sheet down on the counter as the electri
... Read more
cal wire was anchored to the sheet and too short to reach the counter below. I used some jars to prop up the removed sheet so that there would not be any strain on the electrical wires. The wires connected to the motor with a bracket that was removable by hand. The old motor was mounted with one screw and a small arm that slid into a groove at the bottom of the microwave. I installed the new motor with the screw. At first I missed the groove and it was kind of crooked. I immediately detected and corrected my error . I made sure the piece inside the microwave that turns the turntable was aligned on the motor shaft. I closed it up and was delighted to see my food turning again!
By the way, the microwave is actually an Ewave, made by MC Appliance Corp., the makers of Magic Chef. It came with the house in 1994.
By the way, the microwave is actually an Ewave, made by MC Appliance Corp., the makers of Magic Chef. It came with the house in 1994.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jeff from Cape Coral, FL
- Parts Used:
- R0154048
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Turntable stopped working
I removed the old turntable motor from the microwave and replaced it with the new motor.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- doug from broadway, VA
- Parts Used:
- R0154048
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
turntable stopped
4 screws out and replace motor and 4 screws done.
Was this instruction helpful to you?
Thank you for voting!