MC12J8035CT ((AA-00)) Samsung Microwave Oven Combo - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Raymond from TROY, OH
- Parts Used:
- 3405-001034
- Difficulty Level:
- Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers
The microwave would not turn on or would run with the door open
Other tools that are usefull long needle nose pliers, long thin blade screw driver and small magnetic flashlight. Place the microwave on a work bench and remove the case it cover 3 sides. Place the microwave on a chair so it can stand with the controls up. You are replacing the lower door microswitch. The switch is located behind the control panel in the lower part of the area. The switch is several inches inside this area and your hands will not fit. Take care when moving wires and a couple of sensors. Use the thin blade screwdriver to release a tab holding the switch in place. Do not break this tab. Take the needle nose pliers and remove the switch. Put the wires on the new switch, open the door a short distance so a door lever moves enough to put the microswitch back into the bracket.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Edward from MYRTLE BEACH, SC
- Parts Used:
- DE92-90189S
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Part broke
Got the part and replaced it. Simple. Pleasure to work with
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jason from WASHINGTON, IN
- Parts Used:
- DE92-90189S
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Missing roller guide under glass plate
I used my pocket knife to open the package. I opened the door and removed the plate and set the guide down and put the glass plate back.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- SUSAN from DAVISON, MI
- Parts Used:
- DE60-30016A
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Screw drivers, Wrench set
upper fan motor bad
My repair went terrible as I was sent the wrong motor 2 times. My stove sat in the middle of my small kitchen for 2 weeks. Finally the 3rd was the correct one except I didn't have the right nut so I waited another day for that to be sent. Everything working good now, I just hope the bottom fan doesn't go out after this experience.
Was this instruction helpful to you?
Thank you for voting!