BO4510 (Canada) Makita Sander Polisher

If your motor is running poorly, running intermittently, it is likely in need of new carbon brushes. This part includes a set of two carbon brushes with wire leads and brush springs attached. Changing...

This is a cord guard, also known as a strain reliever, for your power tools. Power tool cords go through a lot of stress during usage, and this part is designed to remove some of that stress from the ...

This is a M4 X 10 countersunk screw, and it is sold individually. This screw is compatible with various models, so its location may differ depending on your equipment. To fasten and unfasten this scre...

This is an Authentic OEM replacement part designed for use with Makita Finishing Sanders. It acts as a support. This part is made out of Plastic with Two (2) Metal Fittings that help to secure it. Inc...

This cord is a genuine Makita replacement part and is sold individually. This cord is made for the double insulated tools shown below It is a two wire cord with two prongs and does not need a ground wire.

This is a Ball Bearing that is sealed on both sides. This is a genuine Makita replacement part that is sold individually. rnrn • Ball bearings minimize friction between 2 parts in your tool that wou...

This is a Genuine OEM replacement part designed for use with Makita Power Tools. It is Sold Individually. This metal Pan-Head Phillips Screw includes a washer. It is used in a variety of applications based on your tool.

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it ha...

This pan head screw is a genuine replacement hardware sourced directly from original equipment manufacturer. It is specially produced for use with a variety of power tools. Please make sure to check a...

This is a Ball Bearing that is sealed on both sides. This is a genuine Makita replacement part that is sold individually. • Ball bearings minimize friction between 2 parts in your tool that would...

This is a genuine Makita replacement part that has been sourced from the original manufacturer to be used with finishing sanders. The metal clamper is part of the base assembly and is used to secure t...

This 5 x 8 carbon brush holder is a genuine OEM replacement part used in various outdoor power equipment. It is a small plastic box with a cavity, and it is located near the engine assembly. The brush...