BO3700 Makita Sander Polisher

If your motor is running poorly, running intermittently, it is likely in need of new carbon brushes. This part includes a set of two carbon brushes with wire leads and brush springs attached. Changing...

This is a cord guard, also known as a strain reliever, for your power tools. Power tool cords go through a lot of stress during usage, and this part is designed to remove some of that stress from the ...

This cord is a genuine Makita replacement part and is sold individually. This cord is made for the double insulated tools shown below It is a two wire cord with two prongs and does not need a ground wire.

This is a self-tapping screw, and it is found on multiple power tools and lawn equipment. This screw is different because it can tap its own hole into tough materials, such as metals and hard plastics...

This is a Genuine OEM replacement part designed for use with Makita Power Tools. It is Sold Individually. This metal Pan-Head Phillips Screw includes a washer. It is used in a variety of applications based on your tool.

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it ha...

This is a Ball Bearing that is sealed on both sides. This is a genuine Makita replacement part that is sold individually. • Ball bearings minimize friction between 2 parts in your tool that would...

This Ball Bearing is sealed on both sides. This is a genuine Makita replacement part that is sold individually. • Ball bearings minimize friction between 2 parts in your tool that would otherwis...

This 5 x 8 carbon brush holder is a genuine OEM replacement part used in various outdoor power equipment. It is a small plastic box with a cavity, and it is located near the engine assembly. The brush...

This a genuine OEM sourced replacement part designed for Makita sanders. This is a foam backing pad which is sold Individually. Over time this part we wear out and will need to be replaced. Changing ...

This authentic replacement ball bearing which is supplied by the original manufacturer, it is specially designed for use with Makita power tools. Ball bearings are used to reduce friction between rota...

This is an authentic manufacturer-sourced replacement part, it is specially designed for use with Makita finishing sanders. Two of these o-rings are used to provide a strong seal for the foot, for cor...