Models
>
GM-818DTC
GM-818DTC LG Refrigerator
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
Special Order
This plastic cover is a genuine OEM replacement part for your refrigerator. This part serves as the frame the glass shelf above your refrigerator crisper. To replace this part, remove the glass shelf...
Special Order
This sturdy white frame sits above your fridge’s crisper drawer, giving you extra shelf space and helping keep fruits and veggies fresh. It’s made for LG and Kenmore models and includes rails undernea...
No Longer Available
In Stock
Order now and your part arrives by Aug 6
In Stock
Order now and your part arrives by Aug 6
Special Order
$53.58
This part is a temperature sensing devise. It senses the rise in evaporator temperature during a defrost cycle and cycles the defrost heater off after all frost is melted. It is calibrated to permit...
Special Order
In Stock
Order now and your part arrives by Aug 6
In Stock
Order now and your part arrives by Aug 6
This rubber gasket creates a tight seal around your refrigerator or freezer door to keep cold air in and warm air out. It helps maintain temperature and energy efficiency. If needed, soften creases wi...
No Longer Available
Common Problems and Symptoms for GM-818DTC
Viewing 2 of 2Fridge too warm
Fixed by these parts
How to fix it
Freezer not defrosting
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Daniel from TROY, MI
- Parts Used:
- 4930JJ2021A
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
two screws and done
part fit into slot and screwed them down
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Renita from FORT MADISON, IA
- Parts Used:
- 4930JJ2021A
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Broken clip that keeps the lower holder cover from falling off bottom of refregerator
Used a screwdriver to take off broken clip and then used same screwdriver to replace with new clip. Very easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from Ashland, KY
- Parts Used:
- 6615JB2005C
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Refrigerator not cooling
Used a screwdriver to remove covers. Used a blow dryer to defrost coil in freezer. Cut zip tie and removed old controller assembly. Inserted new controller assembly and secured with zip tie. It took 24 hours for the fridge to cool completely. Now it works fine.
Was this instruction helpful to you?
Thank you for voting!