Models > PB195H42LT

PB195H42LT (96042012302) Poulan Lawn Tractor

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for PB195H42LT

Viewing 10 of 10
Keep searches simple, eg. "belt" or "pump".
This part is the replacement washer head screw for your lawn tractor. It is black in color and is approximately an inch and a half in length. This self-threading screw is most commonly used for securi...
In Stock
This is a flat metal washer found in various models of lawn mowers and is sold individually. This flat washer can have various functions depending on the equipment; however, its general purpose is to ...
In Stock
This is an OEM axle cap for lawn tractors and is sold individually. It stops debris from getting into the wheel hub and axle. This axle cap is prone to wear and tear and should be replaced when it is ...
In Stock
This manufacturer-approved bolt and washer assembly is for lawn tractors. Wear work gloves to protect your hands when installing this part.
In Stock
This is an OEM lawn mower deck mandrel spacer washer, sold individually. It measures approximately 43/64-Inches in diameter, 1-1/8-Inches outer diameter, and 5/32-Inches thick (these measurements are ...
In Stock
In Stock
$14.93
This ignition switch has been sourced directly from the original manufacturer and is sold individually (key sold separately). The ignition switch is also sometimes referred to as a starter switch and ...
On Order
This is a flat idler pulley, approved by the manufacturer for use in lawn tractors. The pulley provides tension to the belt. For this DIY repair you will need a wrench and pliers. You will start by re...
In Stock
This ground drive fixed idler pulley is for lawn tractors. 910 inch offset Ground drive fixed idler pulley helps apply tension to the drive belt, allowing the belt to turn. Wear work gloves to...
In Stock
This is a 5/16-inch metal cotter pin and it is sold as an individual part. Cotter pins secure a variety of different assemblies by placing them through a drilled hole in a shaft or bolt, such as on a ...
In Stock
In Stock

Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Common Problems and Symptoms for PB195H42LT

Viewing 2 of 2
Drive system does not work
Fixed by these parts
Fixing Fixing
How to fix it
Will Not Start
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Gary from PILESGROVE, NJ
Parts Used:
532123583
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Take the wheel off. Place the key in the slot. Put the wheel back on.
Just described it.
3 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Steve from DAMASCUS, OR
Parts Used:
598559101
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Mower belt fell off was cut by the drive pulley.
Got the proper length and pulley size belt via serial number. Checked the length prior to ordering to assure the length would be correct.
Took mower onto a flat surface where I could get on both sides of the deck. And then placed the belt on the back pulleys first . Then I routed it through the idler pulleys to the power pulley whe re I turned the pulley with putting finger pressure against the belt as I turned the pulley. And it went on with no problem . It is that simple just be sure to turn the pulley and apply the belt in the same direction at the same time.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Frederick from BINGHAMTON, NY
Parts Used:
532121749
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Front wheels, too much end play
Shimmed the wheels out on axle.. No more slop.
7 of 28 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!