13AJ771S004 (2010) MTD Lawn Tractor - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- J. Alonzo from TULALIP, WA
- Parts Used:
- 783-06424A-0637
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Socket set
1 deck belt cover fell off and the other rusted and loosening
Removed the retaining screws on both belt covers and replaced them with the new ones i purchased.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jerry from GRAND BAY, AL
- Parts Used:
- 783-06424A-0638
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Wrench (Adjustable)
Belt guards broken
Replaced belt guards. Bended in center plates to keep the belts from slipping off. Works like a charm
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Laurie from RICHLANDS, NC
- Parts Used:
- 731-05628
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Socket set, Wrench (Adjustable), Wrench set
Oil Drain Sleeve
I wish this was longer...it's only about 6", barely enough to have the oil flow past the metal plate of the riding lawnmower. I'm going to figure out a way to make a permanent extension something like this video would be SO much better https://www.youtube.com/watch?v=G9ZVoeqr6R8&t=79s
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- michael from eden, NC
- Parts Used:
- 731-04949A
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
Didn't line up very easy
Put one side in bottom first and you have to slightly twist the lens to get the other clips to pop in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- LISA M from BATESVILLE, AR
- Parts Used:
- 737-0300A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Mixer began to make a noise on speed two and higher
We took our 30 plus year mixer apart. I removed the old grease. There was some crumbly looking grease in the main housing gear section where the nylon gear is located. It looked like it had flour mixed in it. Not certain. Removed as best possible all old grease and applied 6 oz. of new Benalene grease to all of the gears. Now it does not make the slight howl sound.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- George from BAY VILLAGE, OH
- Parts Used:
- 747-04332A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
Bent the old one on a stump
Removed one 1/2" bolt to remove old part .
Slipped new part in place. put bolt in open loop and tightened.
Slipped new part in place. put bolt in open loop and tightened.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Randall from GALLIPOLIS, OH
- Parts Used:
- 738-1186A
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
Blade got bend after hit a stump so had to buy new spindle shaft
The repair was a very easy.
Was this instruction helpful to you?
Thank you for voting!