Models > 26K54 > Instructions

26K54 (GTH 96043003100 -2006-11) Husqvarna Lawn Tractor - Instructions

Jump to:

All Instructions for the 26K54

Customer:: Anthony from OLIVEHILL, TN
Parts Used:: 812000029, 532104757
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Pliers, Screw drivers

Wheel bushings were bad

Removed old clip removed rim from tractor, removed grease fitting on rim, took hammer and screw driver knocked out old bushing turned rim over knocked out other bushing. Press in new bushings reinstalled grease fitting slide tire back on tractor, put retaining washers on then locking clip put on dust cover grease at grease fitting. Repeat other side.

12 of 20 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: walter from EDINBURG, VA
Parts Used:: 532403090
Difficulty Level:: Easy
Total Repair Time:: 30 - 60 mins
Tools:: Pliers, Socket set

Broken weld on right axle

Removed wheel (used strong magnet to catch the keeper)
Removed axle assembly from its mounting tube
(used strong magnet again to prevent keeper lose)
Installed replacement axle (again with the magnet)
Lubricated with 90 SAE
Re-installed the wheel (used magnet again to hold the keeper.
Mowed the lawn.

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: MATTHEW from PENNSBURG, PA
Parts Used:: 587686701
Difficulty Level:: Very Difficult
Total Repair Time:: 30 - 60 mins
Tools:: Pliers, Screw drivers, Wrench (Adjustable)

Right axle bent

Replacing belt with no problem. I've ordered the front right axle spindle assembly three times. This is from your parts list and you sent me the part and they did not work at all.

1 person found this instruction helpful.

Was this instruction helpful to you?

Customer:: Travis from PLATTE CITY, MO
Parts Used:: 532110452, 532187257
Difficulty Level:: Really Easy
Total Repair Time:: 30 - 60 mins
Tools:: Socket set

Deflector shield cracked. Need to replace.

Mark the location of the spring so you know how it goes on. Snip off the push nut holding the deflector shield pin. Hammer the pin out. Insert the pin with the spring holding the new deflector shield. Use a socket to steady the push nut and hammer the pin into the push net until secure.

2 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Frederick from BINGHAMTON, NY
Parts Used:: 532121749
Difficulty Level:: Very Easy
Total Repair Time:: Less than 15 mins

Front wheels, too much end play

Shimmed the wheels out on axle.. No more slop.

7 of 28 people found this instruction helpful.

Was this instruction helpful to you?

All Instructions for the 26K54