Models > 12AV566M011

12AV566M011 (2008) Troy-Bilt Lawn Mower

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for 12AV566M011

Viewing 4 of 4
Keep searches simple, eg. "belt" or "pump".
This is a genuine OEM replacement part, it is sold individually. This is the front wheel on the models shown below. There are two of them on each mower. The wheel has a ring gear on the inside whic...
No Longer Available
This is a mulching blade for your lawn mower. It is located underneath the lawn mower deck, and cuts the grass by rotating. This blade has a curved style shell, and includes extra cutting surfaces alo...
In Stock
This zone control cable is for lawn mowers. Zone control cable stops the engine when you let go of the handle. Wear work gloves to protect your hands during this repair.
In Stock
This is a bell blade support, also known as a bell spacer, for your lawn mower. It is fitted between the bottom of the blade, and the blade bolt. This part provides support for the blade. It is made o...
On Order
In Stock
This lock nut is used for lawn and garden equipment, and is sold individually. This nut resists loosening when it is correctly threaded onto a bolt in your tool. The measurements are: the diameter of ...
In Stock
This is a TT screw, but it is also called a fastener, and it is used on multiple outdoor tools. This part is a Tri-Round or Tri-Lobular thread forming screw, it is 0.25 inches in diameter, 0.5 inches ...
In Stock
In Stock
In Stock
In Stock
No Longer Available

Questions and Answers

Be the first to ask our experts a question about this part!

Common Problems and Symptoms for 12AV566M011

Viewing 1 of 1
Mower blade does not cut
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
  • Customer:
    MICHAEL from Kennewick, WA
  • Parts Used:
    734-04018C
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Socket set
The treads on the front drive wheels were worn down to the point that they provided little traction.
Removed a single nut on each end of the drive shaft with the appropriate socket. Wheels then slipped off. Cleaned/polished the shaft with fine sandpaper, lubed with silicone spray, slid on the wheels and reinstalled the nuts with the same socket. Wheels were an exact fit and OEM quality. Done in 15 minutes start to finish.
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • Customer:
    Ronald from WAYNE, MI
  • Parts Used:
    734-04018C
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Socket set
Front drive wheels were wore out
Unbolted old wheels and bolted new wheels to my lawn mower
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • Customer:
    Jay from GERRY, NY
  • Parts Used:
    734-04018C
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
Not the exact fit
I had to drill and tap the ends of the axle and put a 1/4” bolt in to fasten the wheels. The hubs were not the same. They fastened differently.
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!