Models
>
96144000100
96144000100 Poulan Lawn Mower
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for 96144000100
Viewing 2 of 2
Keep searches simple, eg. "belt" or "pump".
$4.99
This is a genuine hex flange locknut for a lawn mower. It attaches to the carriage bolt (sold separately), fastening the axle assembly braces in place. This part is sold individually, however most mod...
In Stock
$14.93
This zone control cable is for lawn mowers.
Zone control cable stops the engine when you let go of the handle.
In Stock
$3.99
This is an OEM part sourced directly from Husqvarna. This handle knob is used on a variety of lawn and garden equipment. Commonly used in lawn mower to secure the handle, and in snow blowers to secure...
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for 96144000100
Viewing 1 of 1
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- James from ASHTABULA, OH
- Parts Used:
- 532183567
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers
Cable was broke.
Pushed the cable through the engine mount.Connected the cable to the engine slider. Pulled cable through the previous tie down connected to the lower end of the bar. Attached the connector on the cable to the hole in the lawn mower bar near the top of the bar.. Attached the top end of the cable to the on/off bar where you push the mower.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Frank from AUSTIN, TX
- Parts Used:
- 532194653
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Pliers
Drive cable broken
Remove the front drive cover and disconnect the old from the drive, hook the new drive cable to the drive, and connect new cable back to the handle. Reinstalled the drive cover, started unit, and test that the drive was working correctly.
Was this instruction helpful to you?
Thank you for voting!