Models
>
PR675Y21RHP
PR675Y21RHP (96142000902) Poulan Lawn Mower
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for PR675Y21RHP
Viewing 2 of 2_WW_1.gif "Page A Diagram and Parts List for 96142000902 Poulan Lawn Mower")
_WW_2.gif "Page B Diagram and Parts List for 96142000902 Poulan Lawn Mower")
Keep searches simple, eg. "belt" or "pump".
$4.99
This is a genuine hex flange locknut for a lawn mower. It attaches to the carriage bolt (sold separately), fastening the axle assembly braces in place. This part is sold individually, however most mod...
In Stock
$14.93
This zone control cable is for lawn mowers.
Zone control cable stops the engine when you let go of the handle.
In Stock
$3.99
This is an OEM part sourced directly from Husqvarna. This handle knob is used on a variety of lawn and garden equipment. Commonly used in lawn mower to secure the handle, and in snow blowers to secure...
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- James from ASHTABULA, OH
- Parts Used:
- 532183567
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers
Cable was broke.
Pushed the cable through the engine mount.Connected the cable to the engine slider. Pulled cable through the previous tie down connected to the lower end of the bar. Attached the connector on the cable to the hole in the lawn mower bar near the top of the bar.. Attached the top end of the cable to the on/off bar where you push the mower.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dennis from MILWAUKEE, WI
- Parts Used:
- 532193498
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Wrench set
Worn high wheel rear bushings.
Remove 3/8 nut with a 9/16 wrench. Re move wheel from mower the remove old bushing clean. Install new bushings (2 piece bushings). Reinstall the wheel on to the mower.
Was this instruction helpful to you?
Thank you for voting!