Models
>
96143009702
96143009702 Husqvarna Lawn Mower
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
$11.20
This is a single black plastic clipping deflector, also sometimes referred to as a discharge chute, for a lawn mower. This part attaches to the mulcher door on the side of the lawnmower deck. It is re...
In Stock
$3.99
This is an OEM part sourced directly from Husqvarna. This handle knob is used on a variety of lawn and garden equipment. Commonly used in lawn mower to secure the handle, and in snow blowers to secure...
In Stock
This is an OEM part sourced directly from Husqvarna. This grade 8 hex head screw is made of metal and measures approximately 3/8 - 24 x 1 ? 3/8. This screw is commonly used in lawn mowers, snow blower...
In Stock
$13.69
This blade adapter is for lawn mowers.
Blade adapter attaches the mower blade to the motor shaft.
Disconnect the spark plug wire before installing this part. Wear work gloves to protect your hands.
In Stock
In Stock
In Stock
$7.46
This idler pulley is sold independently and includes the pre-installed bearings. It is an exact OEM replacement part for the original. This part is found in walk-behind lawn mowers to supply tension t...
In Stock
In Stock
$26.52
(22-inch Deck)
This 4-in-1 blade is for lawnmowers.
The 4-in-1 blade combines the features of a high-lift blade with a mulching blade for bagging, discharging, mulching, and shredding leaves. T...
In Stock
In Stock
In Stock
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Mark from COLUMBUS, OH
- Parts Used:
- 581685101
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
Rear drive wheels bald, no traction
9/16s inch socket, something to prop up one side of the mower (I used a plastic plant pot), and about 5 minutes was all that was needed. Undo the nut on the wheel, remove, replace it with the new one (can't mess it up - just goes on one way which is extremely obvious), replace and tighten the nut -- done. Just that simple. With the new
... Read more
kicks it goes up hill like a champ now (instead of spinning, especially with the grass catcher attached).
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- jerome from ANNISTON, AL
- Parts Used:
- 581952101
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
DRIVE CABLE BROKEN
REPLACED THE DRIVE CABLE.
Was this instruction helpful to you?
Thank you for voting!