Models
>
917374421
917374421 Craftsman Lawn Mower
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
$4.99
This is a genuine hex flange locknut for a lawn mower. It attaches to the carriage bolt (sold separately), fastening the axle assembly braces in place. This part is sold individually, however most mod...
In Stock
$34.86
Wheel 532401274 attaches to each side of the mower deck and propels the lawn mower.
A wrench is required for replacement of this part.
In Stock
$14.93
This zone control cable is for lawn mowers.
Zone control cable stops the engine when you let go of the handle.
In Stock
$3.99
This is an OEM part sourced directly from Husqvarna. This handle knob is used on a variety of lawn and garden equipment. Commonly used in lawn mower to secure the handle, and in snow blowers to secure...
In Stock
This is an OEM part sourced directly from Husqvarna. This grade 8 hex head screw is made of metal and measures approximately 3/8 - 24 x 1 ? 3/8. This screw is commonly used in lawn mowers, snow blower...
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for 917374421
Viewing 1 of 1
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- James from ASHTABULA, OH
- Parts Used:
- 532183567
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers
Cable was broke.
Pushed the cable through the engine mount.Connected the cable to the engine slider. Pulled cable through the previous tie down connected to the lower end of the bar. Attached the connector on the cable to the hole in the lawn mower bar near the top of the bar.. Attached the top end of the cable to the on/off bar where you push the mower.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Russ from ALTENBURG, MO
- Parts Used:
- 532401274
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
My self-propelled lawnmower did not function. The front wheel assist did not work.
I removed one of the wheels and noticed that the gear teeth were worn off. I then checked the other wheel and it was the same. I ordered two replacement wheels and replaced the worn wheels with the new wheels. It took less than 15 minutes to remove the old wheels and replace with the new wheels. It took a ratchet and a 9/16 inch socke
... Read more
t. It was a very easy repair.
Read less
Was this instruction helpful to you?
Thank you for voting!