3703 Makita Laminate Trimmer - Parts

This is a power cord, and it is used with several power tools. It is made of a thick rubber that is tough, and insulated for a long life. It has two 18 gauge wires, and is 8 feet long. When removing y...

This part includes two carbon brushes with wire leads and brush springs. Worn brushes are typically presented as a failed or underperforming motor. Carbon brushes are a part that commonly wears, so it...

This is a cord guard, also known as a strain reliever, for your power tools. Power tool cords go through a lot of stress during usage, and this part is designed to remove some of that stress from the ...

This is a Ball Bearing that is sealed on both sides. This is a genuine Makita replacement part that is sold individually. • Ball bearings minimize friction between 2 parts in your tool that would...

This Ball Bearing is sealed on both sides. This is a genuine Makita replacement part that is sold individually. • Ball bearings minimize friction between 2 parts in your tool that would otherwis...

This item is a genuine Makita part that has been sourced from the original manufacturer to be used with trimmers, circular saws, sanders, routers, nailers, reciprocating saws, laminate trimmers, and p...

This replacement adjustment knob/screw is a genuine Makita part. It is supplied from original equipment manufacturer for use with belt sanders/trimmers. While the belt is running, use the adjusting kn...

This brush cap is a genuine OEM sourced replacement part. It is commonly used on a variety of Makita power tools. This brush cap helps to secure the carbon brush in the brush holder. This cap has exte...

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with circular saws, table saws, masonry saws, planers, demolition hammers, and angle cutter...

This genuine manufacturer-sourced part is specially designed for Makita power tools. It is an important component which provides a tight seal between connected components. Unfortunately, over time it ...

This replacement collect nut is specially produced by the original manufacturer for use with Makita trimmers and routers. It allows a user to secure the collet to the tools shank. This part is made of...

This is a genuine Makita replacement part that has been sourced to be used with routers and trimmers from Makita. This metal collet cone is used to secure cutting bits. The cone closes around the bit ...