PCC641LB (Type 1) Porter Cable Impact Driver

This compression spring is for drills. The compression spring holds tension against the anvil and sleeve to keep the anvil tight on the armature. Disconnect the power before installing this part...

The steel ball is part of the bit holder in an impact driver and is sold individually. The driver bit is held securely by the ball, which fits into the spindle. The ball is attached to the spindle by ...

The compression spring is part of the impact drivers chuck assembly. The spring is found over the anvil shaft and provides tension to pull the chuck collar back after a bit is removed. Over time this ...

This authentic hog ring is sold individually. This part is found in impact drivers, and fits into a groove on the end of the anvil, holding the chuck assembly together. This is a common wear part that...

This is a genuine OEM plain washer and is part of your impact driver chuck assembly. The washer fits over the compression spring and provides a flat surface for the hog ring to sit against. This part ...

This is a genuine OEM part. The DeWALT sleeve is constructed of metal, and is compatible with several impact drivers. This component is fitted in the nose cone, between the spring and washer. The slee...

This is an OEM part sourced directly from the manufacturer. The switch assembly is found in a Porter Cable drill/driver. This part is a complete assembly, including a high-quality plastic trigger sw...